[GMCnet] Governor Seal [message #226846] |
Thu, 24 October 2013 11:22 |
Gary Berry
Messages: 1002 Registered: May 2005
Karma:
|
Senior Member |
|
|
Hey All;
Finally got the governor out of the transmission. I replaced the
bottom gear (thanks for all of the tips on drilling) and it was bad.
Two teeth were worn down. I now need a replacement square-cut O-ring
for the governor. Any idea where I can quickly get one of these? Would
it be the same seal that is on the Turbo-400? Thanks.
--
Gary and Diana Berry
73 CL Stretch in Wa.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|