[GMCnet] Learning more about TBI system [message #218323] |
Wed, 14 August 2013 13:38 |
emerystora
Messages: 4442 Registered: January 2004
Karma:
|
Senior Member |
|
|
When I was putting in the air conditioner compressor, I had it mounted and was putting in the charge with the engine running and all of a sudden the engine cut out. Instantly, no stumble. I checked the spark and that was not the problem. I poured a little bit of gasoline into the intake and it started and ran until the gasoline was burned up. So, I knew I had a fuel problem. I checked all of the TBI fuses and the connectors and could not find the problem. Then somehow I looked across the top of the engine and saw the wire that leads to the knock sensor was laying on top of a header tube. I picked it up and saw that the insulation was burned through and a bare wire was touching the exhaust header. I then tried to start the engine and it started right up and ran fine.
Apparently if the knock sensor wire is grounded the fuel injection will not work.
Emery Stora
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|