GMCforum: GMCnet » Spindle Installation:

Home » Public Forums » GMCnet » Spindle Installation:

Show: Today's Messages :: Polls :: Message Navigator

Spindle Installation: [message #201367]

Mon, 11 March 2013 23:35

noi

Messages: 293
Registered: October 2010
Location: South of Fremont

Karma:

Senior Member

Greetings:

I am getting ready to re-install my spindles into the swing arms and have a question for the group think.

Due to the rear wheels having sat for a long period, prior to purchase, there was a visible amount of moisture trapped in the hubs which resulted in some minimal corrosion/pitting on the lower half of the spindle bearing surface – The upper half looked OK and there did not appear to be any corrosion problems – I thoroughly solvent degreased and Scotch Bright cleaned them, but there is some small amounts of minor/spotty pitting left behind.

So the question is….

Should I rotate them 180, so that the “best” side is down?

Don’t worry about it and put them back in same (original) way.

Have fun and mix them all up (next owner wonder why thrust washer keys every which way) Twisted Evil

Thanks in advance for any thoughts you may have on this Very Happy

Carl P.
76 Birchaven
South of Fremont

Report message to a moderator

[Message index]

		Spindle Installation: By: noi on Mon, 11 March 2013 23:35
		Re: [GMCnet] Spindle Installation: By: USAussie on Tue, 12 March 2013 05:05
		Re: Spindle Installation: By: noi on Tue, 12 March 2013 20:34
		Re: Spindle Installation: By: USAussie on Tue, 12 March 2013 20:47
		Re: [GMCnet] Spindle Installation: By: USAussie on Wed, 13 March 2013 14:10

Previous Topic:	Anyone Got an Extra Sofa Bottom Cushion?
Next Topic:	[GMCnet] Paper is Not Dead!!! (off topic/humor)

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Nov 16 11:56:08 CST 2024

Total time taken to generate the page: 0.01598 seconds