Fold down dinette table [message #197128] |
Sat, 02 February 2013 12:08 |
tphipps
Messages: 3005 Registered: August 2004 Location: Spanish Fort, AL
Karma:
|
Senior Member |
|
|
Okay, I purchased the hardware to make a functioning dinette table. I have the upper attachment points located. However, I do not have a location for the original Lower attachment points, based on the support wire.
Would someone post either a photo of the wire assembly, both up and down, or a copy of the GMC pages that cover the operation of the table. Have no desire to punch additional holes in the side wall that are not needed, or
Tom, MS II
387 miles to Dothan
2012 Phoenix Cruiser model 2552
KA4CSG
[Updated on: Sat, 02 February 2013 12:08] Report message to a moderator
|
|
|