Clearance Light Wires [message #180817] |
Sun, 19 August 2012 14:21 |
SThornbg
Messages: 127 Registered: September 2011
Karma:
|
Senior Member |
|
|
In the process of changing clearance lights to LED sealed units. Back of the coach went fairly smooth except for one loose rivnut. Rather than remove and replace I stuck it down with JBWeld. Got five bright red lights......
When I removed the non-functioning front passenger side light, I found the ground wire attached to the light, but detatched from the inside wire loom - I got a short red pigtail with a male side connector attached.
So, is there a chance I can fish out the other side of the ground wire through the 1/2 inch hole in the roof?
Is there a good way to fish a new wire across to the next light and piggyback a ground?
Am I at the ugly point of having to drop headliner to reconnect that ground?
Any guidance would be greatly appreciated.
Steve Thornburg
South Bend, IN
77 exPB 455 "Tinker Toy"
Steve Thornburg
South Bend, IN
77 exPB 455 "Tinker Toy"
|
|
|