GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] More water pump thoughts/observations
[GMCnet] More water pump thoughts/observations [message #179838] Sat, 11 August 2012 11:46 Go to previous message
Jim Miller is currently offline  Jim Miller   United States
Messages: 501
Registered: March 2008
Karma:
Senior Member
A couple thoughts and observations related to water pump / temperature control issues.

1) Not too long ago Dick Paterson related to me a story about an engine he worked on that had overheating problems under certain operating regimens. After checking all the usual causes of overheating - timing, thermostat, radiator condition, fan clutch, coolant flow, etc. he could not find the problem. Finally, he decided to change the water pump - and found that the old water pump's impeller was not firmly attached to the driving shaft. It would work properly at low RPM and flows but it would slip on the shaft under load.

2) I fought overheating problems for two years in my 455 with 50000 miles. Checked all the usual and not-so-usual stuff but could not find the problem. This year I started the coach for the first time of the season and discovered raw coolant coming out of the left-bank exhaust. Turns out that the left head had a crack between the valves in cyl #1. The walls of #7 also had evidence of coolant incursion from an unknown source.

Here's the water pump tie in.... while reassembling the engine I was installing Mondello's valve-lifter cover. In the process I managed to drop one of the 1/4-20x3/8" bolts down beside the cam and into the oil pan. I could not fish it out with a magnet so I decided to take the timing cover off and fish from the front. In order to save reassembly time I removed the cover with the water pump still attached to it. Once I had the assembly off the engine I discovered that the hole in the driver's side of the timing cover did not properly line up with the matching passage in the water pump. This misalignment caused perhaps 20-30% of the path to be blocked. I resolved the issue by using a carbide burr to port the water pump casting.

Those of you who have your timing cover off the engine for whatever reason might want to check the water pump / timing-cover fit-up.

--Jim Miller
1977 Eleganza II
1977 Royale
Hamilton, OH

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist



Jim Miller 1977 Eleganza II 1977 Royale Hamilton, OH
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] possible vapor lock solution
Next Topic: Inverter for TV
Goto Forum:
  


Current Time: Sun Sep 22 22:12:57 CDT 2024

Total time taken to generate the page: 0.01407 seconds