GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » A/C compressor not engaging
A/C compressor not engaging [message #174208] Thu, 21 June 2012 14:12 Go to previous message
carguy is currently offline  carguy   United States
Messages: 498
Registered: June 2006
Location: Coshocton OH
Karma:
Senior Member
My air conditioner compressor is not engaging. Following the procedure in the maintenance manual I shorted across the terminals on the pressure switch connector and the clutch engages. Per the manual this indicates that the pressure in the line is too low or the switch is defective.

Now my questions:
I'm using DuraCool I'm assuming that the pressure should be 20 -25 psi with the gauge connected to Gauge connection 1 ( see photo http://www.gmcmhphotos.com/photos/misc-gmc-photos/p44570-air-conditioning-clutch-not-functioning.html ). Is my assumption correct?

If the pressure is OK and I need to replace the pressure switch can I remove & replace the switch without opening the line and loosing the DuraCool?

Any comments/suggestions will be appreciated.

Bill Brown
Coshocton OH
'77 Buckeye Cruiser
Change is certain, progress is not

Bill Brown - '77 Buckeye Cruiser
Coshocton OH
carguybill@sbcglobal.net

Report message to a moderator

[Message index]
 
Read Message
Read Message
Previous Topic: Re: [GMCnet] [Poncho] Shipping a gas tank...
Next Topic: Re: [GMCnet] New Campsite web site
Goto Forum:
  


Current Time: Mon Nov 18 05:48:43 CST 2024

Total time taken to generate the page: 0.00484 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software