GMCforum: GMCnet » Patterson Gaskets

Home » Public Forums » GMCnet » Patterson Gaskets

Show: Today's Messages :: Polls :: Message Navigator

Patterson Gaskets [message #171080]

Mon, 28 May 2012 12:01

Chr$

Messages: 2690
Registered: January 2004
Location: Scottsdale, AZ

Karma:

Senior Member

I have a set of Patterson gaskets with the blank off plates going into my coach. One thing I noticed is that the plates have some curling at the edges from the die. Has anyone sanded these smooth, or should I just install them and hope the manifold flattens them?

Manifold R&R is a total pain in the ass, and I don't want to do it a THIRD time due to a problem with sealing. My Mr Gasket set was fine at the heads, The stupid rubber valley wall seal at the rear of the block is what leaked due to splitting. I will be using RTV this time.

-Chr$: Perpetual SmartAss
Scottsdale, AZ

77 Ex-Kingsley 455 SOLD!
2010 Nomad 24 Ft TT 390W PV W/MPPT, EV4010 and custom cargo door.
Photosite: Chrisc GMC:"It has Begun" TT: "The Other Woman"

Report message to a moderator

[Message index]

		Patterson Gaskets By: Chr$ on Mon, 28 May 2012 12:01
		Re: Patterson Gaskets By: WD0AFQ on Mon, 28 May 2012 12:09
		Re: Patterson Gaskets By: Carl S. on Mon, 28 May 2012 13:15
		Re: Patterson Gaskets By: WD0AFQ on Mon, 28 May 2012 15:09
		Re: [GMCnet] Patterson Gaskets By: Jim Miller on Mon, 28 May 2012 15:51
		Re: Patterson Gaskets By: Chr$ on Mon, 28 May 2012 23:24
		Re: Patterson Gaskets By: WD0AFQ on Mon, 28 May 2012 23:53

Previous Topic:	Sullybilt rear suspension update
Next Topic:	[GMCnet] Onan motor mounts

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Nov 18 15:40:46 CST 2024

Total time taken to generate the page: 0.01039 seconds