GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Body isolator pad question
Body isolator pad question [message #159510] Mon, 06 February 2012 14:38 Go to previous message
gbarrow2 is currently offline  gbarrow2   United States
Messages: 765
Registered: February 2004
Location: Lake Almanor, Ca./ Red Bl...
Karma:
Senior Member
My 76 Palm Beach has the thin single strip body pad still completely intact on both sides with adequate clearance for wires, tubes and hoses at the appropriate locations. I don't see any points where the body is not separated from the frame by the body pad.
A section at the front passenger side has slipped out and I'm sure I can reinstall it by loosening the front body hold down bracket and jacking.

The cross section of the pad strip looks like an "I" beam the web of which is about 3/8" thick and the rails are about 1/2"thick. Is it completely compressed or was that the original shape?

I'm not inclined to do a lot of work unless I'm sure the result will be a clear an substantial improvement.

So my question is: Given the condition of my body pad can I expect any improvement if I replace the strips with new body pads or will it be wasted time and effort?


Gene Barrow
Lake Almanor, Ca.
1976 Palm Beach
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: L E D lights won't flash
Next Topic: Re: [GMCnet] Craig's list - I wish him luck......
Goto Forum:
  


Current Time: Thu Oct 24 05:25:45 CDT 2024

Total time taken to generate the page: 0.01501 seconds