GMCforum: GMCnet » OTC 7822A torsion bar tool

Home » Public Forums » GMCnet » OTC 7822A torsion bar tool

Show: Today's Messages :: Polls :: Message Navigator

OTC 7822A torsion bar tool [message #153886]

Wed, 21 December 2011 08:47

Surbo

Messages: 213
Registered: February 2004

Karma:

Senior Member

This tool will do the job, it was made for the K3500 GM trucks. It has a 3/4" bolt with 1" hex head for socket wrench. It is slightly offset to help with more clearance. You can get these at Summit Racing, O,Reillys or watch Amazon or Ebay for some specials. I fabricated a extra support piece for the top of the cross member to spread the load out on the cross member. I will post a pic of that later.

http://www.foxruntools.com/torsionbarunloading.aspx

Bob Drewes in SESD

Report message to a moderator

[Message index]

		OTC 7822A torsion bar tool By: Surbo on Wed, 21 December 2011 08:47
		Re: [GMCnet] OTC 7822A torsion bar tool By: jimk on Wed, 21 December 2011 22:27

Previous Topic:	[GMCnet] Detectors - Smoke - CO2 - LPG
Next Topic:	Torsion bar unloader

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Nov 16 04:37:05 CST 2024

Total time taken to generate the page: 0.00881 seconds