GMCforum: GMC Swap Meet » New Swivel Base needed for drivers seat

Home » Public Forums » GMC Swap Meet » New Swivel Base needed for drivers seat (Drivers seat)

Show: Today's Messages :: Polls :: Message Navigator

New Swivel Base needed for drivers seat [message #143968]

Tue, 20 September 2011 18:57

MikeT

Messages: 225
Registered: November 2009
Location: Marine City, Michigan

Karma:

Senior Member

I acquired some pre owned RV seats. The new drivers seat sits way to high on the stock GMC seat base because of the motors mounted under the seat for power. Fwd/rev/up/down/etc.

Does anyone have a good source for a new or used swivel base that is much lower then stock? I think the original GMC base is about 7", I only need about 4 inches. 3 inches would be better.

I looked at JC Whitney but they look to high.

Thanks

Mike Thomas Marine City, MI 77 ex Palm Beach

Report message to a moderator

[Message index]

		New Swivel Base needed for drivers seat By: MikeT on Tue, 20 September 2011 18:57
		Re: New Swivel Base needed for drivers seat By: Bob Raef on Tue, 20 September 2011 19:13

Previous Topic:	REVCON "Transmode" for Auction
Next Topic:	Original 16.5" GMC wheel covers

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Oct 18 13:25:27 CDT 2024

Total time taken to generate the page: 0.01009 seconds