GMCforum: GMCnet » stearing relay arm bushing

Home » Public Forums » GMCnet » stearing relay arm bushing

Show: Today's Messages :: Polls :: Message Navigator

stearing relay arm bushing [message #133829]

Fri, 08 July 2011 17:07

hertfordnc

Messages: 1164
Registered: September 2009
Location: East NC

Karma:

Senior Member

The Revcon folks call it a bell crank, I think the part is more or less the same, right?

One end has a rubber bushing. The bushings seems to have a short life.

Some folks on the Revcon forum have replaced the bushing with bearings but I'm not sure all the right questions have been asked and answered.

Why did they use a flexible bushing in the first place?

Would changing to a bearing create trauma to the rest of the linkage?

The steering gear is the same as GMC, most of the other components are Toro.

Dave & Ellen Silva Hertford, NC 76 Birchaven, 1-ton and other stuff Currently planning the Great american Road Trip Summer 2021 It's gonna take a lot of Adderall to get this thing right.

Report message to a moderator

[Message index]

		stearing relay arm bushing By: hertfordnc on Fri, 08 July 2011 17:07
		Re: stearing relay arm bushing By: C Boyd on Fri, 08 July 2011 17:35
		Re: stearing relay arm bushing By: hertfordnc on Fri, 08 July 2011 17:44
		Re: [GMCnet] stearing relay arm bushing By: USAussie on Fri, 08 July 2011 17:55
		Re: [GMCnet] stearing relay arm bushing By: hertfordnc on Fri, 08 July 2011 18:59

Previous Topic:	[GMCnet] belts
Next Topic:	New-dash

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Feb 07 04:41:11 CST 2025

Total time taken to generate the page: 0.03819 seconds