Electrical Help Needed [message #121967] |
Fri, 15 April 2011 22:14 |
LEdmcconnell
Messages: 12 Registered: November 2004 Location: Bridgeton, MO
Karma:
|
Junior Member |
|
|
I recently replaced a bad booster switch with a continous duty solenoid. After I reconnected the wiring, the engine was able to start right up, but only after I switched to "Boost". A little later I tried to restart it, but there was no power in the cockpit, either with the switch on "Boost or "Normal". There was no power to the house wiring unless the shore power was hooked up. Both the house & the engine batteries checked more than 12 volts. There was good continuity between both the batteries and the engine. (The house battery is grounded to the frame & the engine battery, to the engine block.)
Can anyone advise me where to check next?
Luther McConnell
'76 Birchaven
Bridgeton, MO
|
|
|