GMCforum: GMCnet » surface rust on engine parts

Home » Public Forums » GMCnet » surface rust on engine parts

Show: Today's Messages :: Polls :: Message Navigator

surface rust on engine parts [message #119016]

Wed, 16 March 2011 16:46

hertfordnc

Messages: 1164
Registered: September 2009
Location: East NC

Karma:

Senior Member

I'm an idiot, (not new information)

Last fall i took the head off, determined the gasket was blown and the head bolts were streached. Then came winter and some other projects and I never looked at the engine again.

Until today-

There is surface rust on all the exposed metal- push rods, head, block, cylinder walls, etc.

What is the recommended course of treatment?

thanks

Dave & Ellen Silva Hertford, NC 76 Birchaven, 1-ton and other stuff Currently planning the Great american Road Trip Summer 2021 It's gonna take a lot of Adderall to get this thing right.

Report message to a moderator

[Message index]

		surface rust on engine parts By: hertfordnc on Wed, 16 March 2011 16:46
		Re: [GMCnet] surface rust on engine parts By: James Hupy on Wed, 16 March 2011 16:52
		Re: [GMCnet] surface rust on engine parts By: WD0AFQ on Wed, 16 March 2011 22:38
		Re: [GMCnet] surface rust on engine parts By: Douglas Norton on Fri, 18 March 2011 02:14
		Re: [GMCnet] surface rust on engine parts By: Mr ERFisher on Fri, 18 March 2011 02:33
		Re: surface rust on engine parts By: Bob de Kruyff on Wed, 16 March 2011 23:27
		Re: surface rust on engine parts By: Matt Colie on Thu, 17 March 2011 05:17
		Re: surface rust on engine parts By: hertfordnc on Thu, 17 March 2011 06:07
		Re: surface rust on engine parts By: philipswanson on Thu, 17 March 2011 08:37
		Re: surface rust on engine parts By: gbarrow2 on Thu, 17 March 2011 17:57
		Re: surface rust on engine parts By: hertfordnc on Thu, 17 March 2011 19:20
		Re: surface rust on engine parts By: Bob de Kruyff on Thu, 17 March 2011 23:17
		Re: surface rust on engine parts By: Keith V on Fri, 18 March 2011 12:48
		Re: [GMCnet] surface rust on engine parts By: USAussie on Fri, 18 March 2011 17:47

Previous Topic:	Caspro GMC
Next Topic:	PVC Fittings

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Nov 15 16:11:22 CST 2024

Total time taken to generate the page: 0.00902 seconds