| Re: [GMCnet] Lathe Project [message #110366] |
Fri, 31 December 2010 11:43  |
Gary Casey
Messages: 448
Registered: September 2009
Karma:
|
Senior Member |
|
|
Paul,
No, no, no - you see, you do the whole thing in your kitchen. That way the hot
part (in the oven) is right next to the cold part (in the fridge). After
heating for at least a half hour, just pull the rack out and lower the tube into
the plate, using the rack to stop it at the exact spot. Then just leave it sit
there until cool. Okay, it will stink up the oven a little (okay, more than a
little if you didn't clean it really well), but surely you can convince Upper
Management that it's all for the good of the cause..... Good luck!
Gary Casey
Thanks Terry. How do I keep it from freezing running from the back of the house
to my shop(detached).
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
