GMCforum: GMCnet » Cad 500 Help

Home » Public Forums » GMCnet » Cad 500 Help

Show: Today's Messages :: Polls :: Message Navigator

Cad 500 Help [message #108496]

Mon, 13 December 2010 17:33

Frank Condos

Messages: 90
Registered: March 2004

Karma:

Member

I am in the process of getting my '73 with the Cad 500 running again. The engine was installed and driven a little by the PO. I have taken the Quadrajet off and cleaned it and adjusted the . When I removed the carb I found a 1" phenolic spacer under the carb. A question, is this a standard installation? My parts list that goes up to 1974 doesn't show it. I understand the use of spacers to keep carb temperature down but I am questioning if it is really necessary since it causes a higher hatch level. What have you non-efi owners found?

Frank Condos
Ahwahnee, CA
A running'76
A soon to be running '73 (I hope)

Report message to a moderator

[Message index]

		Cad 500 Help By: Frank Condos on Mon, 13 December 2010 17:33
		Re: Cad 500 Help By: fred v on Mon, 13 December 2010 17:48
		Re: [GMCnet] Cad 500 Help By: Ken Henderson on Mon, 13 December 2010 18:17
		Re: Cad 500 Help By: Jim Wagner on Mon, 13 December 2010 19:01
		Re: [GMCnet] Cad 500 Help By: Kosier on Mon, 13 December 2010 21:05
		Re: [GMCnet] Cad 500 Help By: jimk on Mon, 13 December 2010 23:21
		Re: [GMCnet] Cad 500 Help By: Douglas Norton on Mon, 13 December 2010 22:26
		Re: Cad 500 Help By: Larry on Tue, 14 December 2010 08:26
		Re: Cad 500 Help By: Frank Condos on Wed, 15 December 2010 22:14

Previous Topic:	[GMCnet] Door Gas Struts
Next Topic:	[GMCnet] Furnace

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Nov 20 11:47:04 CST 2024

Total time taken to generate the page: 0.00612 seconds