GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » AC clutch bearing/ pulley installation
AC clutch bearing/ pulley installation [message #97758] Sun, 29 August 2010 20:29 Go to previous message
Dennis S is currently offline  Dennis S   United States
Messages: 3046
Registered: November 2005
Karma:
Senior Member
Does anyone have a recommended method for installing the bearing/ pulley on to the ac compressor extension/ snout? The MM shows a special tool -- I used a large socket so as to contact the inner race only but the socket wall was too thick and contacted the snout leaving about 1/8 inch still needed to press on.

Thanks,
Dennis

Dennis S
73 Painted Desert 230
Memphis TN Metro

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 1977 Kingsley... finally
Next Topic: Mr. Onan Status
Goto Forum:
  


Current Time: Sun Jan 19 10:03:25 CST 2025

Total time taken to generate the page: 0.01177 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software