Split fan shroud install question [message #91043] |
Sun, 04 July 2010 08:24 |
|
Matt Colie
Messages: 8547 Registered: March 2007 Location: S.E. Michigan
Karma:
|
Senior Member |
|
|
Ken Henderson wrote on Sat, 03 July 2010 21:16 | Replace the OEM fan shroud contraption with a fiberglass one from Frank Jenkins or Bert & Faye Curtis. If not already split, split it in two (horizontally with angle flanges to screw together). Now you should be able to remove the lower 1/2 shroud in <5 min. and make everything on the front of the engine easy to access.
JWID,
Ken H.
|
As long as I am looking at some serious in-season wrench time, Can a split fan shroud be installed without removing the radiator, condenser and trans cooler?
Matt
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|