[GMCnet] Lower ball joint clearance [message #89805] |
Fri, 25 June 2010 07:31 |
Gary Casey
Messages: 448 Registered: September 2009
Karma:
|
Senior Member |
|
|
Iunderstand there is a maximum allowed clearance in the lower ball joint. As best I could find the number is .095. Is that correct? Measured by putting a jack under the lower control arm and levering the tire up and down. I'm having a hard time getting a definitive answer. As I recall, the lower ball joints are designed to have significant clearance. I seem to have one that is less than .095 and one that is a little more. And these are replacement ball joints (bolted).
Thanks,
Gary Casey
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|