Gauge Installation/Location of Sending Units [message #89227] |
Sat, 19 June 2010 13:23 |
Oldngray
Messages: 544 Registered: August 2009 Location: Punta Gorda Florida
Karma:
|
Senior Member |
|
|
Have looked for the Oil Pressure and Water Temp sending units, believe I have them identified but would like to be certain.
There is a sending unit on the upper front left of the engine, beside the T Stat housing (Water Temp?), as well as another sending unit just below it on the front of the engine and is dome shaped (Oil Pressure?).
What is/are these two sending units?
On the Right side of the engine opposite what I think is the water temp unit there is a plug, believe it was for a TVS?. Can this location be used for a new Water Temp sending unit?
For installing the Voltmeter, the instructions tell me to connect to the "Brown" wire from the Alternator. Heh, I do not have a brown wire coming from my Alt. Hints appreciated.
Lastly, On our Coaches, do we have Positive or Negative Dimmer control for our Instrument lights?
I do have the Manuals on CD, however, I am not too swift when it comes to reading Elect Diagrams. I am pretty good about following Instructions though.
Thanks much for helping me on this project. Do not have my Lower Panel yet but hope to get it next week from Mr. Jenkins.
Richard MacDonald
Punta Gorda, Florida
Sold our TZE April 2015
|
|
|