GMCforum: GMCnet » Offset bushings, upper A-arms

Home » Public Forums » GMCnet » Offset bushings, upper A-arms

Show: Today's Messages :: Polls :: Message Navigator

Offset bushings, upper A-arms [message #88425]

Sun, 13 June 2010 17:30

midlf

Messages: 2212
Registered: July 2007
Location: SE Wisc. (Palmyra)

Karma:

Senior Member

I looked in the photo archive and Gene's site and couldn't find a clear answer for this. According to some notes I have from the Amana convention:

"When using offset upper A-arm bushings that if the bushing is in the front the arrow should point towards the ball joint. If installed in the rear the arrow should point away from the ball joint."

Therefore I would presume that if you are using two offset bushings in the upper arm they would both be installed as noted above. Front towards ball joint, rear away from the ball joint.

Is this correct?

Steve Southworth
1974 Glacier TZE064V100150 (for workin on)
1975 Transmode TZE365V100394 (parts & spares)
Palmyra WI

Report message to a moderator

[Message index]

		Offset bushings, upper A-arms By: midlf on Sun, 13 June 2010 17:30
		Re: [GMCnet] Offset bushings, upper A-arms By: jimk on Sun, 13 June 2010 17:39
		Re: [GMCnet] Offset bushings, upper A-arms By: jimk on Sun, 13 June 2010 17:41
		Re: [GMCnet] Offset bushings, upper A-arms By: jimk on Sun, 13 June 2010 17:44
		Re: [GMCnet] Offset bushings, upper A-arms By: USAussie on Sun, 13 June 2010 18:54
		Re: [GMCnet] Offset bushings, upper A-arms By: John Sharpe on Sun, 13 June 2010 21:19
		Re: [GMCnet] Offset bushings, upper A-arms By: Steven Ferguson on Mon, 14 June 2010 06:50
		Re: [GMCnet] Offset bushings, upper A-arms By: Steven Ferguson on Mon, 14 June 2010 06:51

Previous Topic:	Converting to Duracool
Next Topic:	[GMCnet] Checking Intgerest: Treasure Island

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Oct 11 01:23:26 CDT 2024

Total time taken to generate the page: 0.00834 seconds