GMCforum: GMCnet » distributor hold down MISSING

Home » Public Forums » GMCnet » distributor hold down MISSING (timing maintained by rust)

Show: Today's Messages :: Polls :: Message Navigator

distributor hold down MISSING [message #86579]

Sun, 30 May 2010 05:58

hertfordnc

Messages: 1164
Registered: September 2009
Location: East NC

Karma:

Senior Member

pretty strange, the coach ran fine but when i bumped the distributor in the course of removing the manifold, it moved.

Underneath where the clamp should have been there is just a barely visible remnant of a broken stud.

I'm not optimistic about an EZ-out. I think i want to drill through and tap a new hole.

What's on the other side of the stud? bell housing?

If i keep a vaccum on the drilling operation can i risk a few chips going into the hole?

thanks

Dave

Dave & Ellen Silva Hertford, NC 76 Birchaven, 1-ton and other stuff Currently planning the Great american Road Trip Summer 2021 It's gonna take a lot of Adderall to get this thing right.

Report message to a moderator

[Message index]

		distributor hold down MISSING By: hertfordnc on Sun, 30 May 2010 05:58
		Re: [GMCnet] distributor hold down MISSING By: Steven Ferguson on Sun, 30 May 2010 07:03
		Re: [GMCnet] distributor hold down MISSING By: emerystora on Sun, 30 May 2010 08:02
		Re: distributor hold down MISSING By: Matt Colie on Sun, 30 May 2010 08:50
		Re: distributor hold down MISSING By: Harry on Sun, 30 May 2010 10:49
		Re: distributor hold down MISSING By: Mike O'Connell on Sun, 30 May 2010 12:32
		Re: distributor hold down MISSING By: hertfordnc on Sun, 30 May 2010 14:08
		Re: distributor hold down MISSING By: wally on Sun, 30 May 2010 17:55
		Re: distributor hold down MISSING By: Ernest Dankert on Mon, 31 May 2010 08:01

Previous Topic:	[GMCnet] hide away table
Next Topic:	[GMCnet] Spark Plug Apps Update

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Oct 14 09:15:48 CDT 2024

Total time taken to generate the page: 0.00765 seconds