| Re: [GMCnet] Tuck'n the front bumper [message #76346] |
Thu, 11 March 2010 16:25  |
Steven Ferguson
Messages: 3447
Registered: May 2006
Karma:
|
Senior Member |
|
|
Still broke from what I've been reading here. I prefer the digest version.
On Thu, Mar 11, 2010 at 11:43 AM, Carl Stouffer <carljr3b@yahoo.com> wrote:
> OK, thanks Steve. That sounds easy enough.
>
>> Carl,
>> Once you drill a hole in the cylinder (down side) give the silicone a
>> chance to bleed out. Save it for something else if you can. No
>> spring, just shove them back to where you want them and then drill
>> and tap a couple retaining bolts to keep them there. We used a plasma
>> cutter at the COOP but got a pretty good bang when we cut through
>> using all that heat. I think drilling might be safer.
>
> Carl S.
> '75 ex-Palm Beach
> Tucson, AZ.
>
> By the way, I can't seem to get on the forum today.
>
>
>
>
>
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
--
Steve Ferguson
'76 EII
Sierra Vista, AZ
Urethane bushing source
www.bdub.net/ferguson/
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
