Plastic Heat duct part [message #73160] |
Sun, 07 February 2010 11:33 |
jwillard
Messages: 118 Registered: May 2004 Location: Silver City, NM
Karma:
|
Senior Member |
|
|
I have a plastic Heater Duct that attaches to the floor and the side of the Sink cabinet. It's intended to be a Cold air return and I beleive there was another piece that attached to the square opening for a outlet vent. I have the barrel chairs in my coach and it sits right under the rear of the two seats. My ductwork has changes so I no longer need this.
Need to clean out the shop a bit and I hate to see parts that are getting harder and harder to come by, go to the dump. Contact me if this is something you can use. Make an offer. Pictures are here...
http://www.gmcmhphotos.com/photos/showgallery.php?cat=5398
Jeff Willard
Silver City, NM
1973 ex-Glacier
|
|
|