GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Toilet leaks, Damp Flooring
Toilet leaks, Damp Flooring [message #61148] Thu, 22 October 2009 13:22 Go to next message
Oldngray is currently offline  Oldngray   United States
Messages: 544
Registered: August 2009
Location: Punta Gorda Florida
Karma: 0
Senior Member
I pulled the carpet from the Twin bed and Bath area (Dry Bath) found that the floor is damp, not wet but definite moisture. It looks like it travels from the Toilet area across to the water heater area. Dry everywhere else.

Has anyone else had a similar problem, and what was the solution?


Any suggestions?


Richard MacDonald Punta Gorda, Florida Sold our TZE April 2015

[Updated on: Fri, 23 October 2009 16:51]

Report message to a moderator

Re: Toilet leaks, Damp Flooring [message #61424 is a reply to message #61148] Sat, 24 October 2009 05:40 Go to previous messageGo to next message
Oldngray is currently offline  Oldngray   United States
Messages: 544
Registered: August 2009
Location: Punta Gorda Florida
Karma: 0
Senior Member
Sure would like some input on this. Want to install the wood flooring but hesitate until I can solve this.

Richard MacDonald Punta Gorda, Florida Sold our TZE April 2015
Re: Toilet leaks, Damp Flooring [message #61427 is a reply to message #61148] Sat, 24 October 2009 08:11 Go to previous messageGo to next message
rgleas is currently offline  rgleas   United States
Messages: 48
Registered: May 2009
Location: Tulsa, Ok.
Karma: 0
Member
I would not suspect the toilet as much as I would suspect the shower drain or another leak like the hot water tank.

The reason that I would not suspect the toilet is because of the way it is mounted and attached to the blackwater tank. If you have a leak in the toilet it should leak into the shower and thendown the shower drain as opposed into the coach.

I had a leak in the shower drain on mine that was caused by the plumbers putty that was used to seal the drain to the shower getting old and brittle.

The connections for the shower drain are unique to the caoch once you get past the drain itself. They are also not very accessable.

If you pull the board just below the bath on the hallway side, you can see a catch pan just under the shower trap if it is full of water it is probably a good place to start looking.

With a struggle I was able to take mine apart and repair the leak, but it was not easy.
Re: Toilet leaks, Damp Flooring [message #61457 is a reply to message #61148] Sat, 24 October 2009 12:24 Go to previous messageGo to next message
WD0AFQ is currently offline  WD0AFQ   United States
Messages: 7111
Registered: November 2004
Location: Dexter, Mo.
Karma: 207
Senior Member
Richard, I have a wet bath. I had a leak at the back of toilet, where water comes in to the valve. The valve was bad. Can you see behind the toilet? Feel back there where the water line comes and is attached to the toilet. I think that is about the only place it can leak. It will put water down around the base of the toilet. I bought the expensive part and fixed it. Was just barely leaking. The following year I got a new China Bowl and saved the expensive part for some other GMCer in Ga.
Dan


3 In Stainless Exhaust Headers One Ton All Discs/Reaction Arm 355 FD/Quad Bag/Alum Radiator Manny Tran/New eng. Holley EFI/10 Tire Air Monitoring System Solarized Coach/Upgraded Windows Satelite TV/On Demand Hot Water/3Way Refer
Re: Toilet leaks, Damp Flooring [message #61616 is a reply to message #61457] Sun, 25 October 2009 18:04 Go to previous message
ggroth is currently offline  ggroth   United States
Messages: 282
Registered: February 2004
Location: Carson City NV
Karma: 0
Senior Member

Richard, I had the same trouble as Dan/Terri; When I got the bowl out and tried to look around, the old plastic just gave away here and there. I just bought the China one from Camping World for $200.00. It is a high rise that my wife likes and is a snug fit in the area, but works great. You may have some damage in the plywood under the toilet and the bolt pattern has to be changed. It unscrews from the tank, but hard to get it started.
Like many things, it'll take longer than you think to complete the job! Best o' luck.


geo groth '73 260 Sequoia Carson City Nevada 89703
Previous Topic: [GMCnet] Solar monitoring and inverters
Next Topic: Going all Electric
Goto Forum:
  


Current Time: Fri Nov 15 18:06:20 CST 2024

Total time taken to generate the page: 0.01515 seconds