GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMC Swap Meet » 1974 GMC PARTS
1974 GMC PARTS [message #49486] Tue, 14 July 2009 18:11 Go to next message
Tin Gerbil is currently offline  Tin Gerbil   Canada
Messages: 236
Registered: October 2006
Location: Vancouver Island, B.C.
Karma: 0
Senior Member
Priced in US Dollars

Air bag with aluminum cones Date 2002??? $100

Air Tank with Pressure Gauge $50 NOT SS

Air Compressor $50 Not GMC Original

Two Rear Suspensions; Bogie arms, 5000 miles on new pins and bushings, spindles, bearings and seals, brake lines, wheel cylinders, brake shoes and drums. No air bags. $1000 each

Fuel selector valve $35

Fuel Vapor Separator $45

Ride Height Control Valve $45

One clean fuel tank with recent sender, complete with brackets and straps. No Onan feed in it. $250

One used black water tank, needs new galley fitting spun on can be fixed locally. $140 with new fitting.

4 burner Magic Chef stove top, $75 Range hood $25.

Tilt steering column with key, shift lever and turn signal stock with cruise control. $75

Front Axle $150

Heater motor with squirrel cage fan $50

Brake master cylinder, needs kit, Clean inside, $25

Brake Vacuum Booster $25

Hydraulic wiper motor, with arms and spindles $50

Accelerator cable $20

Shifter cable $30

Rear Cast Iron Shock Frame mount, $20

Head pipes, mufflers with heat shields and "Y" $100.

One forward galley/dinette window screen frame, two rear. $20 each

All above parts in NANAIMO, B.C. Canada

The following parts in Washington State;
Heater control, $20
Monitor Panel (Water, propane, voltage, holding tank) $30



Gordon '74 Canyon Lands "Tin Gerbil" Vancouver Island, B.C.

[Updated on: Sun, 09 August 2009 16:31]

Report message to a moderator

Re: 1974 GMC PARTS [message #49523 is a reply to message #49486] Wed, 15 July 2009 02:19 Go to previous messageGo to next message
braef is currently offline  braef   United States
Messages: 3
Registered: September 2008
Location: San Antonio, TX
Karma: 0
Junior Member
Gordon

Do you have the gas foot pedel?

What is the condition of the rubber bushings in the rear Caspro Shocks. Do the shocks have the upper and lower pin bolts with nuts and washers?

Thanks,


Bob "Oldkid" Raef - San Antonio, TX - A 1977 Royale Rear Bath - "The Colonel"
Re: 1974 GMC PARTS [message #49578 is a reply to message #49486] Wed, 15 July 2009 15:43 Go to previous messageGo to next message
Dan Borlase is currently offline  Dan Borlase   Canada
Messages: 743
Registered: May 2008
Location: Kelowna B.C. Canada
Karma: 0
Senior Member
Gord...
I'll take you up on your offer re; front clip complete with Eng.
trans./final drive, etc.


I'll email you re details.
Dan (former PB) Kelowna
Re: 1974 GMC PARTS [message #49617 is a reply to message #49486] Thu, 16 July 2009 06:15 Go to previous messageGo to next message
JohnP is currently offline  JohnP   United States
Messages: 1
Registered: July 2009
Location: Virginia Beach, VA. USA
Karma: 0
Junior Member
Do you the plastic clips that hold up the end of the sunvisors? I have one broken one, but would like to get 2 to make sure they match. I'm in Virginia Beach, VA., in the US. By the way, I love your area in July and August. Razz

John P Virginia Beach, VA
Re: 1974 GMC PARTS [message #49664 is a reply to message #49523] Thu, 16 July 2009 17:20 Go to previous messageGo to next message
Tin Gerbil is currently offline  Tin Gerbil   Canada
Messages: 236
Registered: October 2006
Location: Vancouver Island, B.C.
Karma: 0
Senior Member
Please try Michael Bozardt for parts. It is not practical to ship from B.C. to Texas.
Thanks;
Gordon


Gordon '74 Canyon Lands "Tin Gerbil" Vancouver Island, B.C.

[Updated on: Sat, 18 July 2009 21:51]

Report message to a moderator

Re: 1974 GMC PARTS [message #49665 is a reply to message #49523] Thu, 16 July 2009 17:24 Go to previous messageGo to next message
Tin Gerbil is currently offline  Tin Gerbil   Canada
Messages: 236
Registered: October 2006
Location: Vancouver Island, B.C.
Karma: 0
Senior Member
I should have replied that yes I do have the gas pedal. I do have all the shock bushings and three only lower cast frame brackets, with rusty pins, bolts, nut and washers. I would not re-use unless they can not be found new. The cost to ship is more than the value of new parts.

Gordon '74 Canyon Lands "Tin Gerbil" Vancouver Island, B.C.
Re: 1974 GMC PARTS [message #49683 is a reply to message #49665] Thu, 16 July 2009 21:43 Go to previous messageGo to next message
Bob Raef is currently offline  Bob Raef   United States
Messages: 165
Registered: July 2009
Location: Lubbock, TX
Karma: 0
Senior Member
Gordon:

Thank you for this information. I will contact Michael.



Bob Raef, KF5TYA
(575) 973-2273
Re: 1974 GMC PARTS [message #73322 is a reply to message #49486] Tue, 09 February 2010 00:13 Go to previous messageGo to next message
captjack is currently offline  captjack   United States
Messages: 271
Registered: February 2010
Location: Sebastopol, California
Karma: 1
Senior Member
Is the airbag w/ aluminum cones still available?
Thanks,
Jack Christensen - K6ROW
captjack@sonic.net


Jack Christensen - K6ROW, '76 Glenbrook/Clasco - "The Silver Bullet", Sebastopol, CA
Re: 1974 GMC PARTS [message #73377 is a reply to message #49486] Tue, 09 February 2010 18:02 Go to previous messageGo to next message
Glenn is currently offline  Glenn   Canada
Messages: 92
Registered: February 2004
Location: Northwestern Ontario
Karma: 2
Member
Does the front axle have CV joints attached? If so I will take it. I am working/living away from home and must travel to town for internet so response may take a couple of days. I see you live in Nanaimo, my parents live there so if you cannot drop it off I will arrange for pickup.

HTH.........
Glenn
76 Glensbroke
Re: 1974 GMC PARTS [message #138140 is a reply to message #49486] Tue, 09 August 2011 04:26 Go to previous messageGo to next message
mike miller   United States
Messages: 3576
Registered: February 2004
Location: Hillsboro, Oregon
Karma: 0
Senior Member
This thread is just over 2 years old.

He has sold the parts from the parts coach, scrapped the rest and no longer reads the forum.

If you are looking for something, start a new thread.

Do not expect a reply to this thread.


Mike Miller -- Hillsboro, OR -- on the Black list
(#2)`78 23' Birchaven Rear Bath -- (#3)`77 23' Birchaven Side Bath
More Sidekicks than GMC's and a late model Malibu called 'Boo' http://m000035.blogspot.com
Re: 1974 GMC PARTS [message #138151 is a reply to message #138140] Tue, 09 August 2011 08:13 Go to previous messageGo to next message
Dennis S is currently offline  Dennis S   United States
Messages: 3046
Registered: November 2005
Karma: 2
Senior Member
No Message Body

Dennis S
73 Painted Desert 230
Memphis TN Metro

[Updated on: Sun, 14 August 2011 17:15]

Report message to a moderator

Re: 1974 GMC PARTS [message #138658 is a reply to message #49486] Fri, 12 August 2011 07:41 Go to previous message
cbwoodsr is currently offline  cbwoodsr   United States
Messages: 1063
Registered: February 2004
Karma: 0
Senior Member
a Spammers accout name..?

CBWood
77 Kingslay
MWC OK
ONLINE PARTS PROGRAM
www.GMCMHParts.com

Previous Topic: Trade GMC for airplane
Next Topic: WANTED sun visop and front fender surounds
Goto Forum:
  


Current Time: Mon Sep 30 23:45:46 CDT 2024

Total time taken to generate the page: 0.00946 seconds