Victron Combiner Install. [message #367025] |
Sun, 03 October 2021 12:49 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma: 4
|
Senior Member |
|
|
Hello all,
I am installing a Victron Combiner, Cyrix-ct and keeping it attached to the existing isolator.
I have the (2) large brass post on the combiner hooked up to the outside post on the isolator and the #86 ground post connected to ground.
Is post #85 generally ignored and do I need to install 120A fuses on the heavy cables going to the isolator outer terminals?
Thanks in advance,
Tom K.
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|
Re: Victron Combiner Install. [message #367029 is a reply to message #367025] |
Sun, 03 October 2021 14:33 |
lqqkatjon
Messages: 2324 Registered: October 2010 Location: St. Cloud, MN
Karma: 5
|
Senior Member |
|
|
I have installed 3 in the same manner. No issues.
No need to fuse, and yes.. that post is ignored in out application. It is a start assist that basically does the battery boost function when cranking. But we pull too many amps when cranking our coach so leave that wire off. (Not to mention it would add a bunch of work to hook up).
Jon Roche
75 palm beach
EBL EFI, manny headers, Micro Level, rebuilt most of coach now.
St. Cloud, MN
http://lqqkatjon.blogspot.com/
|
|
|
Re: Victron Combiner Install. [message #367030 is a reply to message #367025] |
Sun, 03 October 2021 14:56 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma: 4
|
Senior Member |
|
|
Jon,
Thank you and I will follow your advice.
Take care,
Tom K.
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|