[GMCnet] Engine removal hoist needed [message #363737] |
Wed, 28 April 2021 09:37 |
BobDunahugh
Messages: 2465 Registered: October 2010 Location: Cedar Rapids, IA
Karma: 11
|
Senior Member |
|
|
I've done all three ways. If you have the trolly device, not hard. I have one now, Out the front is handy if you're rebuilding everything up there. But you'll need Dave L's special tooling. Or a Bobcat end loader. With extended pallet forks. I have that. Out the bottom. Tall heave 6-ton jack stands. And a foldable A frame for over the hatch.
Then a wireless, hand held remote controlled winch. Have those. My humble input. Pick your poison.
Bob Dunahugh
78 Royale that I replace everything in it 5 years ago.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|
|
[GMCnet] Re: Engine removal hoist needed [message #364942 is a reply to message #364941] |
Wed, 23 June 2021 21:12 |
jkim.phd
Messages: 8 Registered: April 2021
Karma: 0
|
Junior Member |
|
|
I’d love to rent/borrow your hoist if they are near Southern California.
James
1976 26’ Palm Beach
Buena Park, CA
> On Jun 23, 2021, at 7:02 PM, Grant Schaffer wrote:
>
> I have on eon the west coast I have built.
> Grant
> --
> 1974 GMC Sequoia 26'
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|