[GMCnet] Sol - Aire is crap [message #363278] |
Tue, 06 April 2021 15:01 |
Hanson Email
Messages: 110 Registered: March 2020
Karma: -1
|
Senior Member |
|
|
Has anyone welded an extension on the exhaust to get the heat and exhaust
away from the side of the coach or rerouted the intake air so not to pick up
exhaust ?
I can come up with another stainless cover for the exterior but still want
to solve the exhaust/intake issues.
Dean The Resourceful Norse Hanson
75 Avion.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|
Re: [GMCnet] Sol - Aire is crap [message #363280 is a reply to message #363278] |
Tue, 06 April 2021 16:01 |
lqqkatjon
Messages: 2324 Registered: October 2010 Location: St. Cloud, MN
Karma: 5
|
Senior Member |
|
|
I don't understand the issue with getting the vent further away????
sol air problem is a steel burner that rusts out. there is no issues with the exterior venting.
Jon Roche
75 palm beach
EBL EFI, manny headers, Micro Level, rebuilt most of coach now.
St. Cloud, MN
http://lqqkatjon.blogspot.com/
|
|
|
Re: [GMCnet] Sol - Aire is crap [message #363289 is a reply to message #363278] |
Tue, 06 April 2021 22:03 |
Rick Staples
Messages: 126 Registered: May 2014 Location: Johnstown, Colorado, USA
Karma: -1
|
Senior Member |
|
|
Dean,
Not sure why you want to relocate the exhaust/intake for your Sol-Aire. The outside air intake is for combustion air ONLY. It is totally separate from the interior air that is heated and circulated by the furnace. In fact, the intake and exhaust ports are actually further apart than those on other furnaces like the Colemans. If you're getting CO or fumes inside your coach, you may have the leaking (rusted out) heat exchanger everyone talks about around here. OTOH, I just had my functioning Sol-Aire out and partially apart (shortened the plenum 3/4" to make room for a catalytic heater, a "PLatinum Cat", the one that's vented, in front of the Sol-Aire.). I can say the old Sol-Aire is solid and well-made, and the heat exchanger is made of fairly heavy-gauge steel. That said, I can't understand why they made the plenum chamber out of beautiful stainless steel, and the heat exchanger out of plain steel. And yes, I do have a working CO detector.
I did have a problem with the exhaust port however. Seems the previous owner (before I bought it in 1996) of my coach used it for skiing in Jackson Hole, and it must have been cold. Looks like he had the old Sol-Aire cranking full blast 24/7, as it actually melted about 1/8"-1/4" of the fiberglass right around the exhaust port. Of course this might have been due to mud-dauber wasp nests too. Anyhow, I removed the flue adaptors, cleaned them up and lined the exhaust area (on the outside of the body and within the louver) with aluminum, formed to fit snugly into the adaptor and sealed to it with hi-temp (700 degree) Permatex. Incidentally, the exhaust flue pipe is supposed to have air drawn in over it from the cabin by the circulating fan, but it must be positioned properly vis-a-vis its flue adaptor.
My 2ยข, HTH
Rick Staples
Rick Staples, '75 Eleganza, Johnstown, CO
"Advice is a dangerous gift, even from the Wise to the Wise, and all paths may run ill." -Tolkien
|
|
|
Re: [GMCnet] Sol - Aire is crap [message #363299 is a reply to message #363278] |
Wed, 07 April 2021 08:45 |
jhbridges
Messages: 8412 Registered: May 2011 Location: Braselton ga
Karma: -74
|
Senior Member |
|
|
If you insist on using the Sol-Aire be sure you have a working CO detector in the coach and test it each time you need the furnace. Sol-Aire essentially got sued out of business for asphyxiating people with leaky burner chambers in their furnaces.
The RV furnaces have the burner chamber under pressure, unlike a home forced air furnace which runs the burner at less than outside pressure. Newer RV furnaces use stainless steel burner chambers which resist rust and corrosion. Sol-Aire used mild steel in their chambers and holes were a fairly common problem.
--johnny
Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
I forgive them all, save those who hurt the dogs. They must answer to me in hell
|
|
|