Home » Public Forums » GMCnet » Hole in my transmission pan!!!! Broke down
Hole in my transmission pan!!!! Broke down [message #360126] |
Sun, 15 November 2020 14:27  |
aaronanalog
 Messages: 23 Registered: February 2016 Location: Full Time Traveling
Karma: -2
|
Junior Member |
|
|
In Mammoth springs ar. Pouring out trans fluid. May have snapped the chain trying to get off the road. Need help if anyone is near by. Could use a jack and a ride to the parts store to try to plug the hole or remove it and hammer it back out then get it welded up tomorrow.
|
|
|
|
|
|
Re: [GMCnet] Hole in my transmission pan!!!! Broke down [message #360161 is a reply to message #360131] |
Mon, 16 November 2020 15:38   |
NextGenGMC
 Messages: 146 Registered: December 2017 Location: Washington State
Karma: -1
|
Senior Member |
|
|
James Hupy wrote on Sun, 15 November 2020 14:30One thing to avoid if at all possible. Straddling anything lying in the
center of your travel lane. That tranny pan is vulnerable. I guess you
found that out the hard way. I hope you didn't toast your transmission
running it low on fluid. Should be a replacement pan in the hands of
another GMCER in your area. Hope you can make the connections you need.
Jim Hupy
Salem, Oregon
Good advice. On my 4x4 I have a rock guard plate covering the bottom of the engine and transmission to protect them from damage when on rough trails. Would it be helpful to make something like this for our GMCs? Or do you think it will only increase heat holding capacity (reduce air flow and cooling) of the engine compartment and thus be more of a detriment?
Vadim Jitkov
'76 Glenbrook 26'
Pullman, WA
|
|
|
Re: Hole in my transmission pan!!!! Broke down [message #360162 is a reply to message #360126] |
Mon, 16 November 2020 16:51   |
LNelson
 Messages: 335 Registered: December 2008 Location: Springfield, MO
Karma: 0
|
Senior Member |
|
|
Any update? I have a pan. I am two hours from you. Do you have a toad? On a short leash so let me know. Larry Nelson 417 849 2997.
Larry Nelson Springfield, MO
Ex GMC'er, then GM Busnut
now '77 Eleganza ARS WB0JOT
|
|
|
|
|
|
Re: [GMCnet] Hole in my transmission pan!!!! Broke down [message #360175 is a reply to message #360171] |
Tue, 17 November 2020 09:06   |
Ken Henderson
 Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma: 9
|
Senior Member |
|
|
I consider Matt's Ragusa pan advice excellent. Last summer (2019), before
the Wuhan Virus hit us, I came around a curve and down a hill in N. GA to
find a railroad track across the road. Too close to react, I saw what the
tracks, rather than having gentle approaches, stood about 4" above the road
surface. When the front wheels hit the first track I could feel the front
end leave the ground. I never felt the 2nd track, but I did feel and hear
something strike the pavement when we landed. When the shoulder permitted
me to stop, a mile or two down the road, I got out and checked the front
end. There was no obvious damage, but the fins on the bottom of the Ragusa
pan were unusually shiny. Nothing was running out of the engine.
Back home on the service rack I took a better look at everything. There
seemed to be no damage to the tires nor the Manny One-Ton front
suspension. But the fins on the transmission pan were almost obliterated
at the rear of the pan -- scraped off by the highway asphalt when the GMC
landed after its aborted takeoff! But no other obvious damage -- it's
still leaking only at the flange, as it always has. Perhaps that
lubrication on the bottom helped it survive the crash?
Ken H.
On Tue, Nov 17, 2020 at 9:41 AM Matt Colie via Gmclist <
gmclist@list.gmcnet.org> wrote:
> NextGenGMC wrote on Mon, 16 November 2020 16:38
>> Good advice. On my 4x4 I have a rock guard plate covering the bottom of
> the engine and transmission to protect them from damage when on rough
>> trails. Would it be helpful to make something like this for our GMCs?
> Or do you think it will only increase heat holding capacity (reduce air flow
>> and cooling) of the engine compartment and thus be more of a detriment?
>
> Vadim,
>
> Chaumière is an elder lady and at her age there is strike damage to both
> the transmission pan and both fuel tanks. She used to go to Mexico a lot
> and I do not know where or how.
>
> While strike damage should always be a concern, I don't know where you
> could mount such a guard on a TZE. I would not worry about the possible air
> flow cooling loss as both the engine and the transmission have adequate
> coolers in the system. If one were concerned, I would think that a Regusa
> pan
> might be a good answer.
>
> One of my Jeeps had a heavy plate brazed to the bottom of the engine pan
> and it caused me plenty of greif, but I never had to worry about the oil
> pan.
>
> Matt
> --
> Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL,
> GMCES
> Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum
> Brakes with Applied Control Arms
> SE Michigan - Near DTW - Twixt A2 and Detroit
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|
Re: [GMCnet] Hole in my transmission pan!!!! Broke down [message #360183 is a reply to message #360175] |
Tue, 17 November 2020 14:11   |
NextGenGMC
 Messages: 146 Registered: December 2017 Location: Washington State
Karma: -1
|
Senior Member |
|
|
Ken Henderson wrote on Tue, 17 November 2020 07:06I consider Matt's Ragusa pan advice excellent. Last summer (2019), before
the Wuhan Virus hit us, I came around a curve and down a hill in N. GA to
find a railroad track across the road. Too close to react, I saw what the
tracks, rather than having gentle approaches, stood about 4" above the road
surface. When the front wheels hit the first track I could feel the front
end leave the ground. I never felt the 2nd track, but I did feel and hear
something strike the pavement when we landed. When the shoulder permitted
me to stop, a mile or two down the road, I got out and checked the front
end. There was no obvious damage, but the fins on the bottom of the Ragusa
pan were unusually shiny. Nothing was running out of the engine.
Back home on the service rack I took a better look at everything. There
seemed to be no damage to the tires nor the Manny One-Ton front
suspension. But the fins on the transmission pan were almost obliterated
at the rear of the pan -- scraped off by the highway asphalt when the GMC
landed after its aborted takeoff! But no other obvious damage -- it's
still leaking only at the flange, as it always has. Perhaps that
lubrication on the bottom helped it survive the crash?
Ken H.
Ken, have you considered writing as a hobby? I bet you could put together a collection of stories for all ages. The way you describe things make my ribs ache from laughing. GMC's aborted takeoff - very clear visual on that one
Vadim Jitkov
'76 Glenbrook 26'
Pullman, WA
|
|
|
Re: [GMCnet] Hole in my transmission pan!!!! Broke down [message #360185 is a reply to message #360183] |
Tue, 17 November 2020 14:35  |
Ken Henderson
 Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma: 9
|
Senior Member |
|
|
Thanks for your comments, Vadim. Glad you enjoyed the writeup.
With a USAF flying career behind me, I could think of no more apt
description than "crash landing" during an "aborted takeoff" for we
experienced. :-)
Ken H.
On Tue, Nov 17, 2020 at 3:13 PM Vadim Jitkov via Gmclist <
gmclist@list.gmcnet.org> wrote:
> Ken Henderson wrote on Tue, 17 November 2020 07:06
>> I consider Matt's Ragusa pan advice excellent. Last summer (2019),
> before
>> the Wuhan Virus hit us, I came around a curve and down a hill in N. GA to
>> find a railroad track across the road. Too close to react, I saw what
> the
>> tracks, rather than having gentle approaches, stood about 4" above the
> road
>> surface. When the front wheels hit the first track I could feel the
> front
>> end leave the ground. I never felt the 2nd track, but I did feel and
> hear
>> something strike the pavement when we landed. When the shoulder
> permitted
>> me to stop, a mile or two down the road, I got out and checked the front
>> end. There was no obvious damage, but the fins on the bottom of the
> Ragusa
>> pan were unusually shiny. Nothing was running out of the engine.
>>
>> Back home on the service rack I took a better look at everything. There
>> seemed to be no damage to the tires nor the Manny One-Ton front
>> suspension. But the fins on the transmission pan were almost obliterated
>> at the rear of the pan -- scraped off by the highway asphalt when the GMC
>> landed after its aborted takeoff! But no other obvious damage -- it's
>> still leaking only at the flange, as it always has. Perhaps that
>> lubrication on the bottom helped it survive the crash?
>>
>> Ken H.
>
> Ken, have you considered writing as a hobby? I bet you could put together
> a collection of stories for all ages. The way you describe things make my
> ribs ache from laughing. GMC's aborted takeoff - very clear visual on that
> one :lol:
> --
> Vadim Jitkov
> '76 Glenbrook 26'
> Pullman, WA
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|
Goto Forum:
Current Time: Sat Mar 15 16:38:18 CDT 2025
Total time taken to generate the page: 0.00762 seconds
|