GMCforum: GMCnet » 73 Waste outlet size vs FloJet portable macerator size

Home » Public Forums » GMCnet » 73 Waste outlet size vs FloJet portable macerator size

Show: Today's Messages :: Polls :: Message Navigator

73 Waste outlet size vs FloJet portable macerator size [message #333089]

Tue, 05 June 2018 15:08

DetroitDan

Messages: 51
Registered: March 2017
Location: Taylor, MI

Karma: 0

Member

Up until now, I didn't realize there are different size waste outlets. The bayonet fitting on the inlet of the FloJet is much smaller than the bayonet on the coach.

I couldn't find an adapter via and online search.

Have others run into this?

Dan Wallace
Detroit Metro
1974 Canyon Lands 260
Headers, 3.55, 16"
Floor plan 26-9
Honda 6010
Harrison 4-bag

Report message to a moderator

Re: 73 Waste outlet size vs FloJet portable macerator size [message #333090 is a reply to message #333089]

Tue, 05 June 2018 15:30

Scott Nutter

Messages: 782
Registered: January 2015
Location: Houston/San Diego

Karma: 4

Senior Member

Dan,
Call Flojet directly, the tech people there are very good and friendly. You need the 3inch adapter. You can see what im talking about if you google Flojet portable macerator. Flojet will also tell you where to get one at the cheapest price.
Scott

Scott Nutter 1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final drive, Quad bags, Dave Lenzi super duty mid axle disc brakes, tankless water heater, everything Lenzi. Alex Ferrera installed MSD Atomic EFI Houston, Texas

Report message to a moderator

Re: [GMCnet] 73 Waste outlet size vs FloJet portable macerator size [message #333093 is a reply to message #333090]

Tue, 05 June 2018 15:55

jimk

Messages: 6734
Registered: July 2006
Location: Belmont, CA

Karma: 9

Senior Member

If you use a 3" one, you will only dump half the tank as it will cavitate
at that point. That is why the people in the know use the small inlet and
use an off set reducer to draw out the lower 1/3 . Even that is not enough,
so we now have a unit made for us by Lyn Clark that will pull down to the
1/4- 1/8 of the tank.
Call me and I'll assist you if you want.

On Tue, Jun 5, 2018 at 1:30 PM, Scott Nutter wrote:

> Dan,
> Call Flojet directly, the tech people there are very good and friendly.
> You need the 3inch adapter. You can see what im talking about if you google
> Flojet portable macerator. Flojet will also tell you where to get one at
> the cheapest price.
> Scott
> --
> Scott Nutter
> 1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final
> drive, Quad bags, tankless water heater, everything Lenzi. Alex Ferrera
> installed MSD Atomic EFI
> Houston, Texas
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>

--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502

Report message to a moderator

Re: 73 Waste outlet size vs FloJet portable macerator size [message #333099 is a reply to message #333089]

Tue, 05 June 2018 16:45

Matt Colie

Messages: 8547
Registered: March 2007
Location: S.E. Michigan

Karma: 7

Senior Member

DetroitDan wrote on Tue, 05 June 2018 16:08

Up until now, I didn't realize there are different size waste outlets. The bayonet fitting on the inlet of the FloJet is much smaller than the bayonet on the coach.

I couldn't find an adapter via and online search.

Have others run into this?

Dan,

There are two problems here.
One is that some coaches (SOB) have a 3" dump. Rare, but it happens.
The other is that you may still have the Thetford (white) bayonet on the dump pipe.

If it is the Thetford, the now more common Valterra fitting will be about 1/4' too small.
If you need to see parts, come on by. I do have some of them both here.

I gave you a coach card, didn't I?

Matt

Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit

Report message to a moderator

Re: 73 Waste outlet size vs FloJet portable macerator size [message #333115 is a reply to message #333099]

Wed, 06 June 2018 08:33

DetroitDan

Messages: 51
Registered: March 2017
Location: Taylor, MI

Karma: 0

Member

Thank you all for the information.

I could not find the adaptor I need via a Google search. So, I will call later.

Matt, I do not recall getting a coach card from you.

I emailed, to your gmail address, pictures of the cap and bayonet on my coach.

Dan Wallace
Detroit Metro
1974 Canyon Lands 260
Headers, 3.55, 16"
Floor plan 26-9
Honda 6010
Harrison 4-bag

Report message to a moderator

Re: 73 Waste outlet size vs FloJet portable macerator size [message #333123 is a reply to message #333115]

Wed, 06 June 2018 12:08

Matt Colie

Messages: 8547
Registered: March 2007
Location: S.E. Michigan

Karma: 7

Senior Member

DetroitDan wrote on Wed, 06 June 2018 09:33

Thank you all for the information.

I could not find the adaptor I need via a Google search. So, I will call later.

Matt, I do not recall getting a coach card from you.

I emailed, to your gmail address, pictures of the cap and bayonet on my coach.

Dan,

I got your pictures.
I know that the adapter you need cannot be purchased.
Trying to locate a Thetford bayonet may be a bit of a hunt, but Valterra flanges are everywhere.
Do not try to order the bayonet from Thetford in A2. When they get your order, they hold it for three days before shipping it and you can't walk in there with cash.
Just get the two and if you can't glue them together with some universal plumbing glue because parts don't fit, my lathe can make them fit.
Or, use a short piece of hose between.

I am not scheduling lunches between now and October because we will (hopefully) be traveling all summer.

Matt

Report message to a moderator

Re: 73 Waste outlet size vs FloJet portable macerator size [message #333126 is a reply to message #333089]

Wed, 06 June 2018 13:07

DetroitDan

Messages: 51
Registered: March 2017
Location: Taylor, MI

Karma: 0

Member

I am going to cut the pipe right before the Thetford bayonet.

Glue a new Valterra 3" ABS-to-bayonet on the pipe.

Connect the FloJet directly to the Valterra bayonet.

My coach has a swivel in the pipe from the valve to the outlet behind the bumper. So, draining the entire tank should not be a problem.

I ordered a clear Valterra cap to reduce surprises from the other side . . .

Thank you again for pointing me in the correct direction!

Dan Wallace
Detroit Metro
1974 Canyon Lands 260
Headers, 3.55, 16"
Floor plan 26-9
Honda 6010
Harrison 4-bag

Report message to a moderator

Re: [GMCnet] 73 Waste outlet size vs FloJet portable macerator size [message #333140 is a reply to message #333126]

Wed, 06 June 2018 18:44

sgltrac

Messages: 2797
Registered: April 2011

Karma: 1

Senior Member

A short chunk of automotive hose as an adapter is cheap and easily reversed
if it does not work.

My 2c
Sully
Bellevue

On Wed, Jun 6, 2018 at 2:08 PM Dan Wallace wrote:

> I am going to cut the pipe right before the Thetford bayonet.
>
> Glue a new Valterra 3" ABS-to-bayonet on the pipe.
>
> Connect the FloJet directly to the Valterra bayonet.
>
> My coach has a swivel in the pipe from the valve to the outlet behind the
> bumper. So, draining the entire tank should not be a problem.
>
> I ordered a clear Valterra cap to reduce surprises from the other side . .
> .
>
> Thank you again for pointing me in the correct direction!
> --
> Dan Wallace
> Detroit Metro
> 1974 Canyon Lands 260
> Headers, 3.55, 16"
> Floor plan 26-9
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Sully 77 Royale basket case. Future motorhome land speed record holder(bucket list) Seattle, Wa.

Report message to a moderator

Previous Topic:	Onan generator brushes
Next Topic:	[GMCnet] Slip ring, and brushes distroyed on the Onan.

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Nov 06 11:42:26 CST 2024

Total time taken to generate the page: 0.00550 seconds