GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Final Drive ( 3.21 ) Gear Oil Capacity
Final Drive ( 3.21 ) Gear Oil Capacity [message #307412] Mon, 19 September 2016 15:03 Go to next message
larry.whisler is currently offline  larry.whisler   
Messages: 356
Registered: August 2005
Karma: 8
Senior Member
I just finished installing a 3.21 final drive in the coach.

What is the capacity of the 3.21 final drive?

I checked the 67 Olds Toronado manual on the 3.21 and it states 4 1/2 pints
and I thought that I had read somewhere out here on the forum that the
3.21 final drive should not be filled to the hole in the cover but rather
the fluid should be an inch or two below the hole.

So I add two quarts of gear lube and just as I am finishing up the second quart
it starts running out the hole.

Am I missing something? or is the manual a misprint? The drive was completely empty
when I installed it.

larry

Re: [GMCnet] Final Drive ( 3.21 ) Gear Oil Capacity [message #307414 is a reply to message #307412] Mon, 19 September 2016 15:51 Go to previous messageGo to next message
Dolph Santorine is currently offline  Dolph Santorine   United States
Messages: 1236
Registered: April 2011
Location: Wheeling, WV
Karma: -41
Senior Member
Larry:

I filled the 3.70 in my coach to the hole.

I don’t know for certain if that’s right, so I’m going to follow what you learn here.


Dolph

DE N8JPC

Wheeling, West Virginia

1977 26’ ex-PalmBeach
1-Ton, Sullybilt Bags, Reaction Arms, 3.70 LSD, Manny Transmission, EV-6010

“The Aluminum and Fiberglass Mistress"





> On Sep 19, 2016, at 4:03 PM, larry.whisler wrote:
>
> I just finished installing a 3.21 final drive in the coach.
>
> What is the capacity of the 3.21 final drive?
>
> I checked the 67 Olds Toronado manual on the 3.21 and it states 4 1/2 pints
> and I thought that I had read somewhere out here on the forum that the
> 3.21 final drive should not be filled to the hole in the cover but rather
> the fluid should be an inch or two below the hole.
>
> So I add two quarts of gear lube and just as I am finishing up the second quart
> it starts running out the hole.
>
> Am I missing something? or is the manual a misprint? The drive was completely empty
> when I installed it.
>
> larry
>
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Re: Final Drive ( 3.21 ) Gear Oil Capacity [message #307429 is a reply to message #307412] Mon, 19 September 2016 18:00 Go to previous messageGo to next message
jhb1 is currently offline  jhb1   Canada
Messages: 303
Registered: February 2004
Karma: 0
Senior Member
Hi Larry when I changed the fluid on mine I used a little less than 2 quarts there is about an inch and a half left in the second bottle when it started to flow out.. Takes awhile to settle out when filling

HTH


John H. Bell
77 Royale; QuadBag,Manny OneTon,Honda EV4010, FITech
Montreal Qc.
Re: Final Drive ( 3.21 ) Gear Oil Capacity [message #307432 is a reply to message #307412] Mon, 19 September 2016 18:49 Go to previous messageGo to next message
KB is currently offline  KB   United States
Messages: 1262
Registered: September 2009
Karma: 0
Senior Member
About 1.75 quarts. I just did this yesterday with a Manny-rebuilt 3.21.

Manny got Ragusa 3.21 covers without the fill hole drilled so he could place it lower
than Ragusa was doing because he said filling it too high with oil was causing problems.

Karen
1975 26'
Re: Final Drive ( 3.21 ) Gear Oil Capacity [message #307433 is a reply to message #307432] Mon, 19 September 2016 19:43 Go to previous messageGo to next message
larry.whisler is currently offline  larry.whisler   
Messages: 356
Registered: August 2005
Karma: 8
Senior Member
I have the stock 3.21 cover. i'll check the oil level tomorrow
and see where it's at. I'll probably bend a piece of wire to check
it with.

I am hoping that after settling it is about 2 inches from the bottom
of the hole.

larry
Re: [GMCnet] Final Drive ( 3.21 ) Gear Oil Capacity [message #307452 is a reply to message #307414] Mon, 19 September 2016 23:59 Go to previous messageGo to next message
USAussie is currently offline  USAussie   United States
Messages: 15912
Registered: July 2007
Location: Sydney, Australia
Karma: 6
Senior Member
Dolph,

The case on a 3.21 t0 1 is a planetary gear FD and the case is smaller.

Regards,
Rob M.
USAussie - Downunder
AUS '75 Avion - The Blue Streak TZE365V100428
USA '75 Avion - Double Trouble TZE365V100426

-----Original Message-----
From: Gmclist [mailto:gmclist-bounces@list.gmcnet.org] On Behalf Of Dolph Santorine
Sent: Tuesday, September 20, 2016 6:52 AM
To: GMC List
Subject: Re: [GMCnet] Final Drive ( 3.21 ) Gear Oil Capacity

Larry:

I filled the 3.70 in my coach to the hole.

I don't know for certain if that's right, so I'm going to follow what you learn here.

Dolph


_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org



Regards, Rob M. (USAussie) The Pedantic Mechanic Sydney, Australia '75 Avion - AUS - The Blue Streak TZE365V100428 '75 Avion - USA - Double Trouble TZE365V100426
Re: [GMCnet] Final Drive ( 3.21 ) Gear Oil Capacity [message #307453 is a reply to message #307433] Tue, 20 September 2016 01:06 Go to previous messageGo to next message
jimk is currently offline  jimk   United States
Messages: 6734
Registered: July 2006
Location: Belmont, CA
Karma: 9
Senior Member
3.21 is different than the 3.07 unit.
From what I learned when I did run a 3.21 back in 1982 was that the level
was creating a problem and one of the way to avoid the issue of burping out
was to run it lower.
Larry, I believe you have a baffled vent on your cover to help avoid this.
I ran my vent tube to the height of the tire to assure that it had less
chance of expending fluid
I know the synthetic fluid will also help as the temperature runs lot
cooler.

On Mon, Sep 19, 2016 at 5:43 PM, larry.whisler
wrote:

> I have the stock 3.21 cover. i'll check the oil level tomorrow
> and see where it's at. I'll probably bend a piece of wire to check
> it with.
>
> I am hoping that after settling it is about 2 inches from the bottom
> of the hole.
>
> larry
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>



--
Jim Kanomata
Applied/GMC, Fremont,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org



Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
Re: [GMCnet] Final Drive ( 3.21 ) Gear Oil Capacity [message #307470 is a reply to message #307452] Tue, 20 September 2016 09:08 Go to previous messageGo to next message
Dolph Santorine is currently offline  Dolph Santorine   United States
Messages: 1236
Registered: April 2011
Location: Wheeling, WV
Karma: -41
Senior Member
Thanks. I see that now (I knew there was a reason to have that Oldsmobile manual).


Dolph

DE N8JPC

Wheeling, West Virginia

1977 26’ ex-PalmBeach
1-Ton, Sullybilt Bags, Reaction Arms, 3.70 LSD, Manny Transmission, EV-6010

“The Aluminum and Fiberglass Mistress"





> On Sep 20, 2016, at 12:59 AM, Rob Mueller wrote:
>
> Dolph,
>
> The case on a 3.21 t0 1 is a planetary gear FD and the case is smaller.
>
> Regards,
> Rob M.
> USAussie - Downunder
> AUS '75 Avion - The Blue Streak TZE365V100428
> USA '75 Avion - Double Trouble TZE365V100426
>
> -----Original Message-----
> From: Gmclist [mailto:gmclist-bounces@list.gmcnet.org] On Behalf Of Dolph Santorine
> Sent: Tuesday, September 20, 2016 6:52 AM
> To: GMC List
> Subject: Re: [GMCnet] Final Drive ( 3.21 ) Gear Oil Capacity
>
> Larry:
>
> I filled the 3.70 in my coach to the hole.
>
> I don't know for certain if that's right, so I'm going to follow what you learn here.
>
> Dolph
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Re: Final Drive ( 3.21 ) Gear Oil Capacity [message #307514 is a reply to message #307412] Tue, 20 September 2016 20:31 Go to previous message
Larry is currently offline  Larry   United States
Messages: 2875
Registered: January 2004
Location: Menomonie, WI
Karma: 10
Senior Member
Larry, The first year I ran my 3.21, if I filled it to the fill hole, it would spit out about 1" of fluid. Then I tried running it 1" low and it never spit out any more fluid. Been running it that way since 2005 with no issues. Just make sure the vent, which is located in the center of the left side output shaft plate is not plugged. See this:
http://www.gmcmhphotos.com/photos/fd-visual-differences307-vs-321/p16034.html

and even the rest of the photos in that album for some information on the 3.21.

Bend a 12ga wire at a 90* angle and mark it at 1". The insert in the fill hole and fill to 1" below the fill hole. No need to run another vent up into the engine compartment like some have done. If to full it will still spit it out that high vent. JWID

HTH


Larry Smile
78 Royale w/500 Caddy
Menomonie, WI.
Previous Topic: Oil pan dent
Next Topic: [GMCnet] Height Control Valves Adjustment
Goto Forum:
  


Current Time: Fri Nov 15 18:22:38 CST 2024

Total time taken to generate the page: 0.01354 seconds