|
Re: [GMCnet] How does the frig, and kitchen mods come out. 78 Royale [message #288751 is a reply to message #288700] |
Wed, 14 October 2015 17:30 |
Ray Erspamer
Messages: 1707 Registered: May 2007 Location: Milwaukee Wisconsin
Karma: -3
|
Senior Member |
|
|
My refrigerator comes out by removing some of the plastic panels in
the front and getting access to the screws. Then in the back there
were 2 screws holding it down to the floor.
On Tue, Oct 13, 2015 at 10:52 PM, Bob Dunahugh wrote:
> Got the dinette with raised floor, both beds, LP tank, and all carpet out that I can see. So what are the secrets to these next mods? Finding some mouse damage. But it's been less then expected.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
--
Ray Erspamer
78 Royale - "The Great Lakes Eagle"
Center Kitchen TZE368V101144
Wauwatosa, Wisconsin 53226
Email: 78GMCRoyale@gmail.com
414-484-9431
Web Site: http://ray-lisa.page.tl/
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ray Erspamer
78 GMC Royale Center Kitchen
403, 3.70 Final Drive
Holley Sniper Quadrajet EFI System,
Holley Hyperspark Ignition System
414-484-9431
|
|
|
|
Re: [GMCnet] How does the frig, and kitchen mods come out. 78 Royale [message #288802 is a reply to message #288784] |
Thu, 15 October 2015 09:18 |
sgltrac
Messages: 2797 Registered: April 2011
Karma: 1
|
Senior Member |
|
|
Bob,
IIRC the interior in my 77 royale side dry bath came out in the following
order
Upper cabinets(all)
Kitchen appliances
kitchen counter
kitchen cabinet
Fridge enclosure face panel (screwed to cabinet walls via a nailer)
fridge enclosure forward side wall
rear bed cabinetry (leaving onan and opposite side storage box in place)
bath cosmetic interior walls
bath rear wall
bath face panel
bar cabinet rear of entry door
shower(need all other cabinets out to articulate and remove out entry door)
It was assembled front to rear when built. If you are taking the rear main
body wall with the picture window out anyway then your reassembly options
open up a lot but that wall is a bit of a pandoras box so unless you are
doing it for other reasons I would avoid it. When I pulled the rear wall on
The Pig the body tube went out of square and I had to use a porto-power to
push the opening square to install the rear cap again.
Sully
77 Royale
Seattle
On Wed, Oct 14, 2015 at 7:54 PM, Bob Dunahugh wrote:
>
>
> Ray. I got the frig out. That was simple. Now I need to remove the
> cabinet that the frig went in. Then the kitchen, and bath units. I've
> pulled a lot of screws out. I don't think that glue was used to hold the
> cabinets in.Bob Dunahugh Iowa78 Royale
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Sully
77 Royale basket case.
Future motorhome land speed record holder(bucket list)
Seattle, Wa.
|
|
|