| Onan Parts [message #278825] |
Mon, 01 June 2015 11:02  |
rscortezzo
Messages: 49
Registered: January 2007
Location: Green Valley Arizona/ Flo...
Karma: 0
|
Member |
|
|
In the process of rebuilding the carb in Arizona, when I got to Oregon I found I had left the power needle (the one that goes
into the float bowl) in AZ. I have googled warble sites with no luck. does anyone where I might find this part? Or can I upgrade
to a newer carb?
Tanks for the help
Rich Cortezzo
Green Valley AZ
1978 Eleganza II
F389018
|
|
|
|
| Re: Onan Parts [message #278846 is a reply to message #278825] |
Mon, 01 June 2015 15:02  |
 |
Matt Colie
Messages: 8547
Registered: March 2007
Location: S.E. Michigan
Karma: 7
|
Senior Member |
|
|
rscortezzo wrote on Mon, 01 June 2015 12:02In the process of rebuilding the carb in Arizona, when I got to Oregon I found I had left the power needle (the one that goes into the float bowl) in AZ. I have googled warble sites with no luck. does anyone where I might find this part? Or can I upgrade to a newer carb?
Tanks for the help
The carburetor is a Walboro LMB, but the problem is that it was used on a number of Wisconsin engines with mounted fuel tank, and that is the wrong needle and seat. If you go to a small engine parts store, and ask them, the may just be able to set you up. the rubber tipped needles were apparently all the same. The seat is the bear. You want one with a tiny (like #60) orifice. And< in spite of the manual, just set the float to rest parallel to the upper casting.
Matt
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
