GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Looking for Old Cheap Carbon Canister (Want to create a cut-away)
Looking for Old Cheap Carbon Canister [message #264987] Tue, 28 October 2014 11:05 Go to next message
John Heslinga   Canada
Messages: 632
Registered: February 2011
Location: Edmonton, Alberta, Canada
Karma: 4
Senior Member
I would like to create some cut-away pictures and instructional information to share with everyone on the carbon canister used in out coaches.(especially the early years) (The teacher in me calls out) Does anyone have one they can sell me cheap (shipping will be expensive enough) thanks for looking through your stuff.


John and Cathie Heslinga 1974 Canyonlands 260 455, Manny tranny and 1 ton, 3:70 LS, Red Seal Journeyman, DTE, BEd. MEd. Edmonton, Alberta
Re: Looking for Old Cheap Carbon Canister [message #265091 is a reply to message #264987] Wed, 29 October 2014 16:57 Go to previous messageGo to next message
C Boyd is currently offline  C Boyd   United States
Messages: 2629
Registered: April 2006
Karma: 18
Senior Member
John: PM me an address and I`ll get Cat to check on shipping.

John Heslinga wrote on Tue, 28 October 2014 12:05
I would like to create some cut-away pictures and instructional information to share with everyone on the carbon canister used in out coaches.(especially the early years) (The teacher in me calls out) Does anyone have one they can sell me cheap (shipping will be expensive enough) thanks for looking through your stuff.



C. Boyd
76 Crestmont
East Tennessee
Re: Looking for Old Cheap Carbon Canister [message #265160 is a reply to message #264987] Thu, 30 October 2014 22:33 Go to previous message
John Heslinga   Canada
Messages: 632
Registered: February 2011
Location: Edmonton, Alberta, Canada
Karma: 4
Senior Member
PM Sent Laughing

John and Cathie Heslinga 1974 Canyonlands 260 455, Manny tranny and 1 ton, 3:70 LS, Red Seal Journeyman, DTE, BEd. MEd. Edmonton, Alberta
Previous Topic: rpms at 850 range with adv. timing 16 tdc/ 700 at 10 degrees
Next Topic: Any known engine builder that used grey paint ?
Goto Forum:
  


Current Time: Fri Nov 15 23:10:46 CST 2024

Total time taken to generate the page: 0.00967 seconds