Re: [GMCnet] Engine R&R [message #226405] |
Mon, 21 October 2013 12:10 |
|
hnielsen2
Messages: 1434 Registered: February 2004 Location: Alpine CA
Karma: 0
|
Senior Member |
|
|
Netters
I have a "out the bottom hoist" you are ALL welcome to use.
You can pick it up here in Alpine or pay for shipping out and back.
I built a shipping box for the hoist.
Thank You
Howard
Alpine Ca.
All is well with my Lord
> On Oct 21, 2013, at 10:05, Sean Kidd <fiatkidd@yahoo.com> wrote:
>
>
>
> Through the top...26 foot...keep reading
> I built a gantry with an I-beam and 2" square steel, harbor fright 1-ton trolley and chain fall. Front engine mount, right drive shaft support, intake plate mounted hoist point, raised it through the hole, rolled it back with the trolley, lowered it to a dolly and rolled it to the door where i mounted the engine stand plate, tailed the rear suspension a bit and slid it on the stand, then lowered the air bag and rolled the engine into the garage. I was also in the early stages of a complete interior rehabilitation, now that the inside is "done" I would probably drop it out the bottom.
> --
> 73 Ex-CanyonLands 26' #317 "Oliver"
> Hubler 1-Ton, Quadra Bags, Rear Disc, Reaction Arms,
> Fluorescent Mineral Capital of the World, New Jersey
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
All is well with my Lord
|
|
|