Last Call For Parts 73 23' Seqouia Near Gadsden Alabama Need Help Sunday October 20th Removing Parts [message #225726] |
Tue, 15 October 2013 10:31 |
Devin
Messages: 203 Registered: July 2012 Location: Nashville Tennessee
Karma: 0
|
Senior Member |
|
|
OK. My last visit to the parts coach will be Sunday Octobet 20th. If you need anything you need to let me know if you haven't already. It will be cheap particularly if you help us remove parts. If you know where it is do not go without coordinating with me. Join us about 10:00 am Sunday if you can make it.
Thanks,
Devin
Devin Wells
Nashville, Tennessee
1974 GMC Sequoia 260 "Gilligan"
|
|
|
|
Re: [GMCnet] Last Call For Parts 73 23' Seqouia Near Gadsden Alabama Need Help Sunday October 20th R [message #225772 is a reply to message #225747] |
Tue, 15 October 2013 18:27 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma: 9
|
Senior Member |
|
|
Charles,
It's been many years now, but I went through what you're doing now. My
donut was awfully sun-dried and cracked, so I took it to an upholstery shop
and had it covered. They made it look similar to the common Cadillac
pattern: Stitched around the face. But they did such an awful job that I
paid them, took it home, and ripped the cover off.
Then I glued 1/4" landau top padding foam over it, which turned out to be
pretty easy -- it followed the contour quite nicely. Then I glued over it
a piece of stretchable vinyl. That also went very well except for one
minor flaw: I only had barely enough material for the job and the one
required visible seam fell right below the radio. That straight lap joint,
glued with 3M upholstery cement, never gave any trouble, but was in a
too-obvious location. If I'd planned ahead better, and/or had sufficient
material to redo it, I'd have placed the seam in a less obvious location
(upper left?) and probably never noticed it again.
It was only an hour job and lasted for 7-8+ years until I replaced the
entire dash.
Ken H.
Americus, GA
'76 X-Birchaven w/Cad500/Howell EFI & EBL
www.gmcwipersetc.com
On Tue, Oct 15, 2013 at 4:02 PM, Charles Wood <cbwoodsr@swbell.net> wrote:
>
>
> Looking for a good dash donut...
>
> Thankx
> CBW
> --
> CBWood
> 77 Kingslay
> MWC OK
> ONLINE PARTS PROGRAM
> http://cbwoodsr.no-ip.org/GMCParts/index.asp
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|
|
Re: [GMCnet] Last Call For Parts 73 23' Seqouia Near Gadsden Alabama Need Help Sunday October 20th R [message #225849 is a reply to message #225840] |
Wed, 16 October 2013 13:21 |
jhbridges
Messages: 8412 Registered: May 2011 Location: Braselton ga
Karma: -74
|
Senior Member |
|
|
For those of us going to Gadsden for the Dixielanders and/or the parts coach Sunday keep in mind - the Talladega 500 rolls at 1PM. Unless TV pushes it later in the afternioon. The point being, I 20 will be something oif a joke from about 4P on until fairly late in the evening towards Birmingspam and Atlanta. Depending when you plan on heading out of Gadsden, alternate routing might be a good idea. Both the Alabama and Georgia Do-Rights will be having a feeding frenzy.
--johnny
'76 23' transmode norris
Braselton, GA
--------------------------------------------
On Wed, 10/16/13, Charles Wood <cbwoodsr@swbell.net> wrote:
Subject: Re: [GMCnet] Last Call For Parts 73 23' Seqouia Near Gadsden Alabama Need Help Sunday October 20th R
To: gmclist@temp.gmcnet.org
Date: Wednesday, October 16, 2013, 5:48 PM
send me ur old one.. :d
will probably go with JimB
Just gotta find time to pull it.
Thankx
--
CBWood
77 Kingslay
MWC OK
ONLINE PARTS PROGRAM
http://cbwoodsr.no-ip.org/GMCParts/index.asp
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
I forgive them all, save those who hurt the dogs. They must answer to me in hell
|
|
|
|
|
Re: [GMCnet] Last Call For Parts 73 23' Seqouia Near Gadsden Alabama Need Help Sunday October 20th R [message #225882 is a reply to message #225851] |
Wed, 16 October 2013 18:59 |
jhbridges
Messages: 8412 Registered: May 2011 Location: Braselton ga
Karma: -74
|
Senior Member |
|
|
Well, it looks as if I have a sick dog, so I will be travelling 'toad-less'. I'll be pleased to help if someone is headed over there from Noccalula Falls and back.
--johnny
--------------------------------------------
On Wed, 10/16/13, Devin Wells <devin@classictvcollector.com> wrote:
Subject: Re: [GMCnet] Last Call For Parts 73 23' Seqouia Near Gadsden Alabama Need Help Sunday October 20th Removing P
To: gmclist@temp.gmcnet.org
Date: Wednesday, October 16, 2013, 7:22 PM
That will work great as I thought we would start at 10:00
and be finished in a couple of hours. Need some help
removing windshield.
--
Devin Wells
Nashville, Tennessee
1974 GMC Sequoia 260 "Gilligan"
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
I forgive them all, save those who hurt the dogs. They must answer to me in hell
|
|
|