Onan armature [message #224234] |
Tue, 01 October 2013 18:05 |
Otterwan
Messages: 946 Registered: July 2013 Location: Lynnwood (north of Seattl...
Karma: 0
|
Senior Member |
|
|
Anyone know off the top of their head what the reading across the brush contact surface of the armature should read?
1977 Birchaven, Lynnwood WA - "We may not be able to stop all evil in the world, but I know that how we treat one another is entirely up to us."
|
|
|
Re: Onan armature [message #224237 is a reply to message #224234] |
Tue, 01 October 2013 18:11 |
Otterwan
Messages: 946 Registered: July 2013 Location: Lynnwood (north of Seattl...
Karma: 0
|
Senior Member |
|
|
I should add that I have measured what the manual says. Between the contacts reads essentially dead short. Between each contact and the shaft reads open. I was just wondering if between the contacts should read some resistance, like the field coil does, or if nearly 0 ohms is normal.
1977 Birchaven, Lynnwood WA - "We may not be able to stop all evil in the world, but I know that how we treat one another is entirely up to us."
|
|
|
|
Re: [GMCnet] Onan armature [message #224247 is a reply to message #224242] |
Tue, 01 October 2013 18:25 |
Otterwan
Messages: 946 Registered: July 2013 Location: Lynnwood (north of Seattl...
Karma: 0
|
Senior Member |
|
|
Jim jr wrote on Tue, 01 October 2013 16:18 | The resistance ts .3 ohms (three tenths).
Jim Miller
Ham. Ohio
|
That is exactly what I measured! Thank you!
1977 Birchaven, Lynnwood WA - "We may not be able to stop all evil in the world, but I know that how we treat one another is entirely up to us."
|
|
|