speedo printed circuit/connector [message #221933] |
Tue, 10 September 2013 11:37 |
scheibejn
Messages: 35 Registered: March 2013 Location: Stillwater, MN
Karma: 0
|
Member |
|
|
I’m looking for the speedometer printed circuit piece with male contact pins and the female connector that goes with these contacts. The parts book has them listed as:
6294647 CONNECTOR p/c inst. Panel harness. gauge cluster/speedometer
6493204 CIRCUIT ASSY (used w/8989366) SOA
The one I have on the vehicle had no connector and only two surviving male contact pins. I wasted lots of time by replacing the necessary pins with tiny bronze bolts/washers/lock washers/epoxy and ring connectors. It worked just fine until the bolts shorted out on the flexible air vent hose that I replaced with aluminum.
My vehicle is 1977 Kingsley.
GMC PARTS STICKER
Printed in U.S.A. 6-0975 110376 CORRECTION S19119 342933
SERVICE PARTS IDENTIFICATION
V.I.N. TZE167V100796 W/BASE 160 SE NONE
Wish to purchase these parts
If you have them let me know cost+shipping. If not, but know who might have them, please let me know.
James N Scheibe
6351 St. Croix Trail North #230
Oak Park Heights, MN 55082
scheibejn@gmail.com
651 430-2081 home
651 897-2702 cell
Jim Scheibe
1977 Kingsley 26' GMC PD(parlor diesel)4106, 93 Volvo, 96 Volvo,
Oak Park Heights MN 55082
On the gorgeous St. Croix River lookin' at WI shore
|
|
|
Re: speedo printed circuit/connector [message #221942 is a reply to message #221933] |
Tue, 10 September 2013 12:28 |
lqqkatjon
Messages: 2324 Registered: October 2010 Location: St. Cloud, MN
Karma: 5
|
Senior Member |
|
|
Jim,
I would try to contact Jim Bounds down at the GMC coop. I would think he would have a whole speedometer or whatever dash parts you need in the junk bin, because a good portion of his restoration gets an entire new dash cluster.
Jon Roche
75 palm beach
EBL EFI, manny headers, Micro Level, rebuilt most of coach now.
St. Cloud, MN
http://lqqkatjon.blogspot.com/
|
|
|
Re: speedo printed circuit/connector [message #222049 is a reply to message #221942] |
Wed, 11 September 2013 13:05 |
scheibejn
Messages: 35 Registered: March 2013 Location: Stillwater, MN
Karma: 0
|
Member |
|
|
I got an email from Jim Bounds this morning, talked to him and his wife and gave all the information needed to complete the transaction. All marvelous.
Jim Scheibe
77 Kingsley
Jim Scheibe
1977 Kingsley 26' GMC PD(parlor diesel)4106, 93 Volvo, 96 Volvo,
Oak Park Heights MN 55082
On the gorgeous St. Croix River lookin' at WI shore
|
|
|