GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » Re: [GMCnet] Finally about to pull the 403
Re: [GMCnet] Finally about to pull the 403 [message #208956] Mon, 27 May 2013 12:46 Go to next message
KB is currently offline  KB   United States
Messages: 1262
Registered: September 2009
Karma: 0
Senior Member
> I had similar symptoms to yours and was convinced it was a
> rod. Turned out to be 1 missing and 1 loose bolts on the torque converter.



Thanks Terry. Got any suggestions for how I can check those?
Do I have to pull the tranny, or can they been seen/accessed
from the round hole on the tranny housing?

thanks
Karen
1973 23'
1975 26'
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Karen 1975 26' San Jose, CA

Report message to a moderator

Re: [GMCnet] Finally about to pull the 403 [message #208960 is a reply to message #208956] Mon, 27 May 2013 13:46 Go to previous messageGo to next message
kerry pinkerton is currently offline  kerry pinkerton   United States
Messages: 2565
Registered: July 2012
Location: Harvest, Al
Karma: 15
Senior Member
Pull the starter and the flex plate gravel shield. There are three bolts that hold the torque converter to the flexplate.

Kerry Pinkerton - North Alabama Had 5 over the years. Currently have a '06 Fleetwood Discovery 39L

Report message to a moderator

Re: [GMCnet] Finally about to pull the 403 [message #208991 is a reply to message #208956] Mon, 27 May 2013 19:55 Go to previous message
n6mon is currently offline  n6mon   United States
Messages: 421
Registered: January 2004
Location: San Lorenzo, CA
Karma: 0
Senior Member
On 5/27/2013 10:46 AM, KB wrote:
> Do I have to pull the tranny, or can they been seen/accessed
> from the round hole on the tranny housing?
You can get to them through the inspection hole on the tranny housing.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Terry Taylor
'74 ex-Eleganza SE
San Lorenzo, CA
http://www.n6mon.org
http://dldesignstore.com

Report message to a moderator

Previous Topic: [GMCnet] Tire Advice ~ Load Range
Next Topic: [GMCnet] Installing P30 Master Cyl. HELP
Goto Forum:
  


Current Time: Thu Oct 10 21:23:36 CDT 2024

Total time taken to generate the page: 0.01023 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software