|
Re: [GMCnet] Master Cylinder Pushrod [message #220095 is a reply to message #197731] |
Tue, 27 August 2013 10:42 |
KB
Messages: 1262 Registered: September 2009
Karma: 0
|
Senior Member |
|
|
> emerystora wrote on Sun, 25 August 2013 10:42]Your 69mm (2.72") is close to the 2.63 inches that I and others have used. It is only 2.2mm more. However, make sure that you have enough clearance. If the piston doesn't return all the way you can get some residual pressure on the master cylinder and the brakes. I recommend 0.015 inches (3.8mm) clearance between the end of the push rod and the piston.
think you mean 0.38 mm. 3.8mm is about 0.15 inches, or roughly 10 times
what the clearance should be. The pushrod should be 1/4mm to 1/2mm shorter
than the space available between the MC and booster. (0.010 to 0.020 inches)
Karen
1973 23'
1975 26'
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Karen
1975 26'
San Jose, CA
|
|
|