| Fold down dinette table [message #197128] |
Sat, 02 February 2013 12:08  |
tphipps
Messages: 3005
Registered: August 2004
Location: Spanish Fort, AL
Karma: 9
|
Senior Member |
|
|
Okay, I purchased the hardware to make a functioning dinette table. I have the upper attachment points located. However, I do not have a location for the original Lower attachment points, based on the support wire.
Would someone post either a photo of the wire assembly, both up and down, or a copy of the GMC pages that cover the operation of the table. Have no desire to punch additional holes in the side wall that are not needed, or
Tom, MS II
387 miles to Dothan
2012 Phoenix Cruiser model 2552
KA4CSG
[Updated on: Sat, 02 February 2013 12:08] Report message to a moderator |
|
|
|
| Re: Fold down dinette table [message #197129 is a reply to message #197128] |
Sat, 02 February 2013 12:25  |
C Boyd
Messages: 2629
Registered: April 2006
Karma: 18
|
Senior Member |
|
|
http://www.gmcmhphotos.com/photos/table-brackets/p47255-table-down.html
| tphipps wrote on Sat, 02 February 2013 13:08 |
Okay, I purchased the hardware to make a functioning dinette table. I have the upper attachment points located. However, I do not have a location for the original Lower attachment points, based on the support wire.
Would someone post either a photo of the wire assembly, both up and down, or a copy of the GMC pages that cover the operation of the table. Have no desire to punch additional holes in the side wall that are not needed, or
Tom, MS II
387 miles to Dothan
|
C. Boyd
76 Crestmont
East Tennessee
|
|
|
|
| Re: Fold down dinette table [message #197130 is a reply to message #197129] |
Sat, 02 February 2013 12:33 |
C Boyd
Messages: 2629
Registered: April 2006
Karma: 18
|
Senior Member |
|
|
Tom I just put a couple of new pics of the brackets.
http://www.gmcmhphotos.com/photos/g6281-table-brackets.html
| C Boyd wrote on Sat, 02 February 2013 13:25 |
http://www.gmcmhphotos.com/photos/table-brackets/p47255-table-down.html
| tphipps wrote on Sat, 02 February 2013 13:08 |
Okay, I purchased the hardware to make a functioning dinette table. I have the upper attachment points located. However, I do not have a location for the original Lower attachment points, based on the support wire.
Would someone post either a photo of the wire assembly, both up and down, or a copy of the GMC pages that cover the operation of the table. Have no desire to punch additional holes in the side wall that are not needed, or
Tom, MS II
387 miles to Dothan
|
|
C. Boyd
76 Crestmont
East Tennessee
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
