Lowering the steering column [message #192654] |
Mon, 10 December 2012 15:36 |
zhagrieb
Messages: 676 Registered: August 2009 Location: Portland Oregon
Karma: 0
|
Senior Member |
|
|
I lowered my column about 1 1/4 inches (measured at the instrument panel). Looks like the (blue teflon) splined shaft pulled up about 3/8 of an inch. Should I worry? How long is the shaft?
Glenn
Glenn Giere, Portland OR, K7GAG
'73 "Moby the Motorhome" 26'
|
|
|
Re: Lowering the steering column [message #192658 is a reply to message #192654] |
Mon, 10 December 2012 17:40 |
gbarrow2
Messages: 765 Registered: February 2004 Location: Lake Almanor, Ca./ Red Bl...
Karma: 3
|
Senior Member |
|
|
Glenn, I understand that the potential problem is the binding of the u-joint due to the increased angle caused by lowering the column. I think the joint will bind when turning before the splinde shaft will separate.
Gene Barrow
Lake Almanor, Ca.
1976 Palm Beach
|
|
|