|
Re: [GMCnet] GOOD TOOLS [message #159441 is a reply to message #159429] |
Sun, 05 February 2012 17:47 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma: 9
|
Senior Member |
|
|
Larry,
Seeing your name reminded me of something I thought of and keep meaning to
tell you: When I was told you the essential vacuum lines to connect, I
forgot one: the feed to the little "softball" reservoir up front for the
A/C controls.
Sorry 'bout that. :-)
(For the rest of you, when I visited Larry last month, I noticed that his
engine must be CA-fitted 'cause it's got vacuum lines & junk running
everywhere -- I suggested scrapping most of it instead of trying to figure
it out. Other opinions MAY be welcome.)
Ken H.
On Sun, Feb 5, 2012 at 6:30 PM, larry erd wrote:
> I've been using the Norseman drill bits in the
> hex container for about 5 years or so, very handy
> and very good.
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|