Wiring harness [message #152270] |
Fri, 09 December 2011 13:16 |
rhbelter
Messages: 12 Registered: November 2011 Location: Carmel CA
Karma: 0
|
Junior Member |
|
|
Ahoy, JimmyFolks,
This is my first Jimmy listing, but not my first RV listing.
I have a Silver Eagle conversion (hands-on) -w- a 400hp Cummins M-11 & 10spd RoadRanger OD.
I just got a Jimmy 23' which is sound -w- low miles. . The wiring has been burgled/vandalized. Do any of you have any of the wiring around and about the engine/forward chassis? I can repair/replace the stuff, but wire from a part-out would be better.
Robert H. Belter Carmel CA 93923
ph: 831 625 0670 email: rhbelter@comcast.net
Thanks /s/ Bob
Bob-- Silver Eagle Bus -w- Cummins M-11, and Jimmy 23 in progress. Enjoy /s/ Bob
|
|
|
|
Re: Wiring harness [message #152340 is a reply to message #152270] |
Fri, 09 December 2011 21:49 |
rhbelter
Messages: 12 Registered: November 2011 Location: Carmel CA
Karma: 0
|
Junior Member |
|
|
Ahoy, Dan,
Yes. My comments about my Eagle is only for background. The wires are needed for a regular Jimmy 23' front wheel drive.
Thanks for the look-see.
Enjoy /s/ Bob
Bob-- Silver Eagle Bus -w- Cummins M-11, and Jimmy 23 in progress. Enjoy /s/ Bob
|
|
|
|
Re: Wiring harness [message #152373 is a reply to message #152270] |
Sat, 10 December 2011 00:58 |
|
John Heslinga
Messages: 632 Registered: February 2011 Location: Edmonton, Alberta, Canada
Karma: 4
|
Senior Member |
|
|
Try "Seven" (Jay Fox) in Calgary: (Check out the other posts in the forum) He is currently cutting apart a transmode for a trailer. All of the front wireing harness should be pretty much the same. At least the service manual shows no difference.
Best of Luck
John and Cathie Heslinga
1974 Canyonlands 260
455, Manny tranny and 1 ton, 3:70 LS,
Red Seal Journeyman, DTE, BEd. MEd.
Edmonton, Alberta
|
|
|
|