|
|
|
Re: [GMCnet] Brake line O-ring seals [message #143629 is a reply to message #142819] |
Sat, 17 September 2011 00:19 |
|
USAussie
Messages: 15912 Registered: July 2007 Location: Sydney, Australia
Karma: 6
|
Senior Member |
|
|
Ken,
After I noted that Page 8 of the document you found shows that several different seals are compatible with brake fluid I realized
that the title of this email is misleading.
These seals wouldn't be used on the flared brake lines, they would be used to replace the "normal" flat copper seals that go in
between the fittings on the brake hoses and the calipers whether they are the standard GMC OEM hoses or banjo fittings like on the
Caddy calipers.
The Subject should be: Brake Hose O-ring Seals.
My bad!
Regards,
Rob M.
-----Original Message-----
From: Rob Mueller [mailto:robmueller@iinet.net.au]
Ken,
I ASSUMED these were the same as the ones that Harley Davidson used on the handlebar master cylinder that's why I mentioned them.
However, now that I think about it at the time HD was using silicone brake fluid so I may have screwed up by mentioning them.
I'll check into it some more and get back to the group.
Regards,
Rob M.
-----Original Message-----
From: Ken Henderson
This gives more info. I don't see anything about brake lines.
http://www.parker.com/literature/Seal%20Group/CSS%205125.pdf
Ken H.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Regards,
Rob M. (USAussie)
The Pedantic Mechanic
Sydney, Australia
'75 Avion - AUS - The Blue Streak TZE365V100428
'75 Avion - USA - Double Trouble TZE365V100426
|
|
|