6000 gen question [message #130403] |
Wed, 15 June 2011 20:54 |
chasingsummer
Messages: 434 Registered: May 2011 Location: asheboro, nc
Karma: 0
|
Senior Member |
|
|
choke cable or rod, for someone whose generator works well, how much of the choke line is sticking out past the adjustor nut at the coil end?
thanks bgk
brian
asheboro, nc
75 eleganza, 74 build
119k miles and counting,
DOG HOUSE
|
|
|
|
|
Re: [GMCnet] 6000 gen question [message #130456 is a reply to message #130403] |
Wed, 15 June 2011 22:06 |
jimk
Messages: 6734 Registered: July 2006 Location: Belmont, CA
Karma: 9
|
Senior Member |
|
|
There is a bend on the rod that people bend to adjust the choke, so
the amount extendis not the way to know.
Choke comes on when the engine first starts, then is released after it
starts running.
When cold, the choke should be fully cloed.
On Wed, Jun 15, 2011 at 6:54 PM, brian <chasingsummer@triad.rr.com> wrote:
>
>
> choke cable or rod, for someone whose generator works well, how much of the choke line is sticking out past the adjustor nut at the coil end?
> thanks bgk
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
--
Jim Kanomata
Applied/GMC, Fremont,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|
|
Re: [GMCnet] 6000 gen question [message #130664 is a reply to message #130466] |
Fri, 17 June 2011 20:45 |
chasingsummer
Messages: 434 Registered: May 2011 Location: asheboro, nc
Karma: 0
|
Senior Member |
|
|
after cleaning and talking to i noticed that if i held the choke open just a hair more buy hand that my gen ran great,
i anjusted but only slightly, but i know i am much less than a half inch sticking out past the adjustment nut. i think i still needed just a little, my cable has no bend it it, and since it is hard to use a bend as a measured adjustment, i hope to keep mine straight. i may just set it to half inch before i start it again tomorrow and see what happens. mine started out less than, or maybe equal to a quarter inch,
thansk for the input, focus is on rear breaks tomorrow,
brian
asheboro, nc
75 eleganza, 74 build
119k miles and counting,
DOG HOUSE
|
|
|