GMCforum: GMCnet » [GMCnet] Grease Zerks Jig

Home » Public Forums » GMCnet » [GMCnet] Grease Zerks Jig

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Grease Zerks Jig [message #121249]

Thu, 07 April 2011 18:12

Don Hart

Messages: 87
Registered: October 2009

Karma: 0

Member

Emery

I miss spoke, as meant the spacer by going to deep with the grooves.
How wide and deep. Reading the rest of the your response answers my
question. Thanks
Don
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Re: [GMCnet] Grease Zerks Jig [message #121269 is a reply to message #121249]

Thu, 07 April 2011 20:47

Hardie Johnson

Messages: 483
Registered: January 2004
Location: Raleigh NC

Karma: 0

Senior Member

Don Hart wrote on Thu, 07 April 2011 19:12

Emery
I miss spoke, as meant the spacer by going to deep with the grooves. How wide and deep. Reading the rest of the your response answers my question. Thanks, Don

Don, Not that it really matters, but the computer people out here would like to know what software and hardware you are using to respond to email because your posts and email break the chain of messages in the forum, and apparently in email. Are you hitting the "Reply to:" button, or creating a fresh email response?

Hardie Johnson "Crashj"
1973 26 foot Glacier, White Thing
Raleigh NC

Report message to a moderator

Re: [GMCnet] Grease Zerks Jig [message #121283 is a reply to message #121249]

Thu, 07 April 2011 22:10

emerystora

Messages: 4442
Registered: January 2004

Karma: 13

Senior Member

You would only have to make the grooves about the width of your Dremel cutting wheel..
It would be less than 1/16" deep and 1/16" wide.

On Apr 7, 2011, at 5:12 PM, Don Hart wrote:

> Emery
>
> I miss spoke, as meant the spacer by going to deep with the grooves.
> How wide and deep. Reading the rest of the your response answers my
> question. Thanks
> Don
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Emery Stora
77 Kingsley
Santa Fe, NM

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Previous Topic:	[GMCnet] Don Harts improper use of the GMC Net
Next Topic:	[GMCnet] Grease Zerks Jigs

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Sep 30 17:28:25 CDT 2024

Total time taken to generate the page: 0.00675 seconds