GMCforum: GMCnet » Re: [GMCnet] Revcon to GMC front end

Home » Public Forums » GMCnet » Re: [GMCnet] Revcon to GMC front end

Show: Today's Messages :: Polls :: Message Navigator

Re: [GMCnet] Revcon to GMC front end [message #116768]

Sun, 27 February 2011 12:02

George Zhookoff

Messages: 398
Registered: December 2004
Location: Snellville, GA

Karma: 6

Senior Member

Maybe you should go "Hubler"?
George Zhookoff
78 EL II
Atlanta

----- Original Message -----
From: gmclist-bounces@temp.gmcnet.org <gmclist-bounces@temp.gmcnet.org>
To: gmclist@temp.gmcnet.org <gmclist@temp.gmcnet.org>
Sent: Sun Feb 27 12:17:20 2011
Subject: Re: [GMCnet] Revcon to GMC front end

hertfordnc wrote on Sun, 27 February 2011 12:06
> This was mentioned briefly in the thread about parting out another GMC.
>
> The original Revcon Front end is all Toro. Later models used a custom I-beam assembly but not mine
>
> It's all Toro right out the the five lug hub. Wheel adapters are used to accommodate truck rims.
>
> So the question is, what would it take to put GMC hubs,knuckles, rotors, etc on a stock Toronado?

I think you would also need the beefed up control arms. The lower ball joint has a different taper also.
--
C. Boyd
76 Crestmont by Midas
East Tennessee
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Previous Topic:	will you guys hate me if i cut up another TZE?
Next Topic:	Side door striker

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Nov 19 05:06:43 CST 2024

Total time taken to generate the page: 0.01172 seconds