Home » Public Forums » GMCnet » GMC Parts in Ontario
| GMC Parts in Ontario [message #105363] |
Sun, 07 November 2010 14:13  |
seven
Messages: 322
Registered: July 2008
Location: Calgary Canada
Karma: 0
|
Senior Member |
|
|
These Parts are not mine but I am forwarding them on. Please contact G .Murray ,Maxville ,on. Tel: 613:527:5662
Email: f.louis45@yahoo.ca
GMC MOTORHOME PARTS ‘’ USED PARTS’’
1 ) 350.00 $ : 455 “ Toronado “ Engine complete with front wheel axles ,final drive, transmission, carburetor , electronic ignition ( HEI ) , distributor , etc.....(may be sold separately).
2) 175.00 $ : Final drive : “ 3.05 “ original from a GMC Motor home , ( O.E.M. ) “ original equipment manufacturer “
3 ) 35.00 $ : Left exhaust manifold from a GMC Motor home O.E.M. serial : J407103Lhd2.,
4) 100.00 $ : Hitch “ custom made “for A GMC Motor home ; ready to be install.
5) 35.00 $ : Alternator from a GMC Motor home O.E.M. .
6) 5.00 $ : High energy ignition module “ H.E.I. “ # GM: 9905L56C.
7) 8.00 $ : Air fan, 12 volts , “ to be fix on the panel board.
 5.00 $ : Headlight 12 volts, high and low, type: round one.
9) 8.00 $ : Two (2) , 12 volts headlight (Those headlight are fix on the front bumper ).
10) 10.00 $ : Steel wiper arm and blade ; without the rubber blade. O.E.M.
11) 50.00 $ : Central vacuum , with 11 bags O.E.M
12) 10.00 $ : Wall mounting vent, for the 12 volts electric fan ; to be mounted over the propane stove, O.E.M.
13) 5.00 $ : One ( 1 ) Front axle big nuts 7/8’’ thick, O.E.M..
14) 6.00 $ : Two ( 2 ) rear axle nuts O.E.M.
15) 25.00 $ : Two ( 2 ) sets of windows moulding ; this included ; four ( 4 ) 24 inch .long ( vertical one ) , and four ( 4 ) 48 inch. long, the horizontal one.
16) 15.00 $ : Four ( 4 ) cabinet wire moulding .They are O.E.M. The 12 volts cabinet wire light run behind those moulding.
17) 6.00 $ : Six ( 6 ) Ashtray.
18) 25.00 $ : Dana air compressor motor, 12 volts , with belt ,cover(blue one)and different pieces.
19) 25.00 $ : Hydrostatic fan clutch ; for the 455 motor engine O.E.M.
20) 12.00 $ : Original GMC hydraulic jack(need repairs) O.E.M.
21) 15.00 $ : Two air flute horn .
22) 3.00 $ : Fuse wagner 30 amps #495 “ rectangular shape”.
23) 2.00 $ : One used Timken bearing (front wheel) , cone”LM104949”, “ cup “ LM104911”.
24) 6.00 $ : One long elbow funnel “ used for transmission or final drive. 25) 3.00 $ : Box of different pieces 26) 10.00 $ : Wheel spare cover “ BRAND NEW PIECES
27) 50.00 $ New fuel gas pump ; “ NIEHOFF “ # 23-6289-4 # 41566-E081M , Made in USA ; (this included a use one) .
28) 30.00 $ : One set of new shoe brake “rear brake” , ( this included a set of used shoe with a box of pieces ).
29) 35.00 $ : One set of spare plug wire # NAPA #700241 8mm.
30) 5.00 $ : One fuel filter (cylinder type) : The one who goes in the gas tank O.E.M.
31) 40.00 $ : Gas sender pat.no:2508290, 12 volts ,zero ( 0 )ohms empty to ninety ( 90 ) ohms full , for either the main or auxiliary tank .The sender are installed in the gas tank O.E.M.. 32) 100.00 $ : One water tank sender and one holding tank sender ( both of them are install respectively in the water tank and in the waste tank ) .The both of them come with their Dial gauge reading .The dials are install at the control panel at the main entrance. Can be sold separately; MFD by Texas instruments. Sender: 40.00$ each, Dial gauge 35.00 $ each. Set of two : 60.00 $ O.E.M.
33) 12.00 $ : Hot water heater element ,120 volts ,1000 watts O.E.M.
34) 50.00 $ : A Onan generator kit ; included switch #308-0320 ,condenser #312-0069 , and point set #160-1154 , O.E.M.
35) 18.00 $ : One coil of steel tubing 5/16, 25 foots long (for gas purpose or brake ; not sure I have to check !
36) 8.00 $ : One coil of tubing “this coil is already turn in spiral “ the spiral has around 2 ½ inch of diameter and 8 inch long. With a steel guard shaped in “U”. It’s a GMC part but I do not know the purpose ; if someone know ; let me know please.
37) 10.00$ : Two hatch lock for the front or side panel.
38) 25.00 $ : One ” steel gasket “ to be install over the valve and head; the big one approximately 17 ½ X20 ½ inch. This gasket is need when we rebuilt the motor.
39) 30.00 $ : Seven ( 7 ) Alcoa cap “hug a log “nut covers #001161, and six ( 6 ) “two pieces flanges nuts 9/16 U guard #971195”. From Alcoa .
40) 8.00 $ : One steering boot 41) 100.00$ : One heavy duty motor water pump,” six pales or turbin ” brand new from the factory. Heavy - duty to keep the 455 engine cool.
42) 7.00 $ : One coupler body ¼” n.p.t . for air tank.
43) 50.00 $ : “ Timken” Rear wheel kit: Four (4) rear wheel seal #472015 ,”one ( 1 ) inner bearing cone LM501349 , one ( 1 ) inner cup LM501310 “, ”one ( 1 ) outer bearing cone #15103- S , ” one ( 1 ) outer cup #15243 “. Can be sold separattly.
44 A) 115.00 $ : Front wheel kit : Four (4) front Wheel cup # LM104911 ,Two (2) front Wheel inner seal # 5123 ,Two (2) front wheel outer seal # 5109 . Can be sold separately. 44 B ) 75.00$ : A kit for oversize hub ; this included : Two (2) front cup # LM104912 (over size cup} ; four (4) machined shop ring (to be install between the middle of a A-23 Bower bearing or equivalent (we use only one ring between the bearing ) ; One machined shop sleeve approximately 2” 3/16 x 3 3/16 “this sleeve is machined shop exactly to put in place the sleeve “ and bearing . With this kit you just need to over- size the front hub. If you experience a problem with the front wheel bearing. “ when the bearing turn inside the hub and rip and burn the interior “ just bring the hub to a machined shop to take out the waste and put an oversize bearing cone with one ( 1 ) machined shop ring between using the special sleeve..N.B. The size of the cone do not change.
45) 3.00 $ : One air filter to be place under the panel board ” for the air intake suspension compressor” .
TOOLS
46) 75.00 $ : One commercial puller to remove the front wheel hub.
47) 50.00 $ : One universal “O RING kit” , included 382 pieces; brand new with the case.
48) 60.00 $ : One cooling and vacuum pressure kit tester “ Stant “ ST 270-12270 Made in USA by ” Stant “inc. Manufacturing.” Brand new ”. This is quality.
49) 200.00 $ : Professional socket set ¾” drive 26 pieces. Included socket 7/8 to 2 ½’ (21 pieces), 3 extension :5” ,8’’ , and 16”, One ratchet and one power bar ; included with is steel Box case “Brand new”.
50) 125.00 $ : One used professionals torque wrench; Proto ½’’drive ;” 10 to 150 foot/pound, 18”long.
51) 35.00 $ : One used calliper micrometer Mitsutoyo opening 0” to 8 ½” scale 1/128” or “ 0 to 450mm “ scale 0.05mm.
52) 25.00$ : One used micrometer accurate to 0-0001” ,opening 0 to 1 inch.
53) 15.00 $ : One used timing light 12 volts.
54) 20.00 $ : A- Multimeter “ volts ohm meter “ RCA 0 to 500 volts ac /dc ; Mill. Amps 1.5 to 500 (DCMA) ; ohms scale Rx1 .............. to R x 1,000,000
B; A Multimeter “ volts ohms meter “ EICO AC volts ; 0 to 5 volts , to 15 , to 50 , to 150 , to 500 , to 1500 volts .
DC volts ; 0 to 5 volts, to 15 , to 50 , to 150 , to 500 ,to 1500 volts.
Ohms scale RX1 to.............R X 1,000,000
55) 25.00 $ : One brand new tube bender (steel or copper) ;for ¼ “ ,5/16” and 3/8” pipes.
56) 35.00 $ : One compression gauge tester 0/300 # for engine compression test; Dial 2 ¾” ‘’SCHAUER’’.
VACUUM GAUGES
57) 35.00 $ : One vacuum gauge 0 to 30# For vacuum engine testing; Dial size 3 ¾” Made by US GAUGE CO. N.Y.
58) 30.00 $ : One vacuum gauge 0 to 30# , 0 to 100 KPA , Dial size ; 2 ¾” Brand new Made by US gauge.
59) 10.00 $ : One vacuum gauge 0 to 30 # , Dial size 1 ½’’ Made by BENDIX CO.
PRESSURE GAUGES
60) 35.00 $ : One genuine General Motors Locomotive Pressure Gauge 0 to100 psi Brand new . Made by Marsh instrument Dial size 2 ¾”.
61) 20.00 $ : One pressure gauge 0 to 30 psi Dial size 2”.
62) 35.00 $ : One fuel gas pump AC made by : “ AC Spark Plug “ 12 volts , with switch and “ in and out ” fitting.
63) 5.00 $ : One old fashion gas filter; “glass bulb type”. 64) 2.50 $ : Each or all for 15.00$ = GMC Motor home News issue by Cinnabar “issue #56 to #64. 65) 35.00 $ : One dust sweeper ; who is installed under the rear bumper ; help to keep the rear of the motor home clean . 66) 35.00$ : One inner left fender ; protect the motor compartment again mud splash and water). 67 ) 20.00$ : Five ( 5 ) “genuine GMC Motor home wheel cap “ .
Please contact G .Murray ,Maxville ,on. Tel: 613:527:5662
Email: f.louis45@yahoo.ca
l
Jay Fox
Calgary AB
73 Painted Desert (Turtle)
78 Transmode (Trailer Donor)
[Updated on: Thu, 23 December 2010 01:54] Report message to a moderator |
|
|
|
|
|
|
|
| Re: GMC Parts in Ontario [message #174366 is a reply to message #105363] |
Sat, 23 June 2012 10:59  |
Kudzu
Messages: 377
Registered: November 2011
Location: Marshville, NC
Karma: 0
|
Senior Member |
|
|
Do you have a picture of the bumper? THX...
1976 Eleganza II
1996 Chevy Impala SS
1999 Kawasaki Vulcan Nomad
|
|
|
|
|
|
|
|
|
|
| Re: GMC Parts in Ontario [message #174386 is a reply to message #174378] |
Sat, 23 June 2012 15:28 |
Kudzu
Messages: 377
Registered: November 2011
Location: Marshville, NC
Karma: 0
|
Senior Member |
|
|
I was going to post the same. If you get his email please pass it along. Thanks!
1976 Eleganza II
1996 Chevy Impala SS
1999 Kawasaki Vulcan Nomad
|
|
|
|
Goto Forum:
Current Time: Sat Nov 16 04:53:41 CST 2024
Total time taken to generate the page: 0.03919 seconds
|
GMCforum
Search
Help
Register
Login
Home
